FreeCAD Apply Thickness In 3d Model Tutorial For Beginner

[@daveclark3668]

THANK YOU! Was just going crazy wondering why the heck it would only add thickness to the outside and just watched you change it to a negative thickness to go inside! How did I miss that?! LOL! Thanks, man

[@hankus253]

That was very easy for me to follow. Now with the created cylinder that you ended up with, how would you remove 160 degrees of the shell leaving a 200 degree half pipe? Yep I know a half pipe in 180 but I want to be able to clip this 200 degree section on a second pipe with an O.D. of this section's I.D. .

[@sparkerlbalicog7424]

Do you have tutorial on how to make roof ridge?? Thanks 😊

[@neagoecatalin879]

Hey, thanks a lot for the learning. I do have an issue, thought. If I need a 20mm cylinder, after build the solid, by applying a 1.2 mm thickness the outer diameter gets those 1,2 + 1,2 mm added. I`ve been using Fusion360 and there it`s quite different, does leave the outer diameter fix and it goes to the inside (shell). Is there any equal function in Freecad so I don`t spend more time doing the math? Again, thank you and all the best!

[@Parpinelli31]

Thanks a lot!

[@hafizonramadhan6194]

can thickness = 0 ???