MUST DO!!! Screw in Rocker Studs on sbc heads!

tapping out the press in stud holes for screw in studs!
#nonamenationals #sbc #cylinderheads
Thanks For Watching!
Leave a like and comment if you want to. Subscribe if you want more content.
Instagram: brandt_murphy_garage
Facebook Page: / brandtmurphy
TikTok: @brandt_murphy_garage
Email: [e-mail]

[@christianwise4403]

If I could make make suggestion. When tapping go 1-2 turns n back 1/2 turn to break chip off when tapping anything. Watch in cast iron it’s brittle. Use a starter tap, plug and then bottom tap to cut threads for the entire length of the hole Bering threaded. Good video

[@jasonkimmel3061]

You should probably watch a video on how to properly use a tap. That was painful to watch. I can’t believe your tap didn’t break.

[@richardrivera9116]

You know to use those studs. You have to mill the boss down. But you can use the cheater stud in the head you are doing.

[@rugged04270]

A wise man once told me, you should always go 1/4 turn back for every half turn forward, then you will never break a tap. (but do whatever you want just don't hit me in the face with a volleyball again)

[@brandt_murphy_garage]

Bruh why did I just see this comment

[@rugged04270]

@@brandt_murphy_garage TBH I asked myself the same thing weeks ago.

[@brandt_murphy_garage]

@@rugged04270 shows how much I still use the ol KZbin

[@brandt_murphy_garage]

Wanna change that though

[@Backin_Theday]

I have used electrolysis for rust and crud removal on small parts but I saw a guy on TikTok using it on cylinder heads. I tagged you in his video comments.

[@brandt_murphy_garage]

I’ll check it out!

[@grantlucas6678]

I wish I was there to show you how to use the tap procedure properly,

[@baconunteggs]

How did it go with porting your heads? I can see you haven't had time to put out the video yet. Cheers!

[@joshbohner1712]

Hey man I just did this on my sbc heads all the studs are in the block fits back over them no problem but if I put a straight edge along all 8 studs like two are off the straight edge a very small amount but the block fits fine is this gonna be a problem thanks for any advice or opinions