My Motor Won't Start ! | Arima Sea Ranger Boat Restoration | EP: 6

Motor won't start to installing trim tabs

[@westbourne1956]

You are the Arima master. Can’t wait to watch your next Arima build 😊. Keep up the great videos

[@SoCalSeaChaser]

Thank you Johnny😁 I plan on this being my last restore project for a while, but I’ve said that before lol, and get back into fishing. I hope to have by April, some fishing videos start rolling out.

[@Carl_Black]

Funny you post this. I just re-wired my main switch and both batteries. I better check to see if my starter is spinning in the right direction.

[@SoCalSeaChaser]

Good to double check, simple things always cause the most headaches. The frustration level was at all time high all because I swapped the neg and pos cables lol. I thought I would have seen something when turning the key switch on, but nothing. Also you probably saw in my video I have regular nuts on my battery terminals, that's just for easy taking off and on during my process. Don't ask me how I know this one, lol, but make sure to only use Nyloc nuts on the terminals, otherwise those nuts can vibrate off and leave you stranded for a minute.

[@goodbless6094]

I'm wondering, did you replace your tank fuel sender? If so what part #. Thanks

[@SoCalSeaChaser]

Yes I replaced it with a Geloo (generic brand), KUS USA is supposed to be better, but no issues so far with Geloo. It's a 16" 240-33 ohms fuel sender. It does not go all the way to the bottom, 17" might with the tank I have. But for me the 16" is good because when it reads EMPTY, I know I have roughly 5 gallons left. Thanks for watching ! a.co/d/awA1q7A