Continuing with the Steam roller build. Casting and a couple of failures. Watch until the end.
Пікірлер: 22
@johnbiggs76205 ай бұрын
After years of watching you do castings ....... it never gets old lol. I could watch you do this all day.
@RonaldWalters20105 ай бұрын
Good show as always Mate! :-)
@RustyInventions-wz6ir5 ай бұрын
Nice work. I really would like to get into casting myself. Picked up allot from you guys. Thank you
@boblow21865 ай бұрын
Nice work as always. 👍
@RetroSteamTech5 ай бұрын
Thanks for showing the ones that didn't quite work 👍 The roller is starting look really good. Cheers, Alan.
@Smallathe5 ай бұрын
Really lovely project. Thanks for sharing!
@termlimit5 ай бұрын
Would you ever consider a tour of your work area? I wonder how you manage the sand for packing, then is it left there on the floor? A shop tour would be awesome. Long time viewer of the channel. Always enjoy your content. Thank you.
@myfordboy4 ай бұрын
Here is a tour of my indoor workshop. kzbin.info/www/bejne/lYXYo4mPibehpc0 I don't think I can show much about the garage where the casting is done.
@GermanDarioCarte5 ай бұрын
Genial!!!
@Preso585 ай бұрын
Interesting that the mould failed on the core side. I had the exact same issue on a similarly shaped casting. The harder I rammed the sand, the worse it got.
@tinayoga88445 ай бұрын
@Preso58 My thought was that there wasn't enough pressure to push the air through the sand. And having the trouble section at the bottom of the mold allowed it to fill completely.
@myfordboy5 ай бұрын
I always find it easier if I can remove the pattern from the sand rather than removing the cope from the pattern. removing the cope you cannot rap the pattern.
@myfordboy5 ай бұрын
It's best practice to feed into the thickest part of the mould but i wanted to keep that clean from sprues so tried feeding into the bottom where the part would be cut away. As the thin part cooled first the thick part shrunk as there was no reseve of metal to feed it.
@jae8785 ай бұрын
I’ve noticed that you don’t sift the sand onto the pattern like I’ve seen others do. Is that because of the type of sand you use or do you not find it necessary? Thanks for sharing!!
@myfordboy5 ай бұрын
The way I condition my sand it all gets shifted so no point in it sifting more.
Nice work, could I ask do you use Petrobond here (ie oil bonded sand to those unfamiliar)?
@myfordboy5 ай бұрын
No it is greensand:www.artisanfoundry.co.uk/product_info.php?cPath=21&products_id=38
@garysmith97725 ай бұрын
Just wanted to warn other home shop machinist. I ordered on eBay some tool holders for my Myford quick change tool post. When they finally arrived, they weren’t even close to fitting properly. They are making all kinds of excuses and not accepting the return. I guess I’m out $200. So buyer beware and dealing with these companies overseas.
@alandavis64295 ай бұрын
You need to visit a real foundry and see how real foundrymen at least you finally listened to my last post and cut the fill and vent holes with brass pipes like every other foundryman does. Do you feel a little stupid arguing with me about raming around the pipes like you used to do?
@imajeenyus425 ай бұрын
Let’s see your 140-part series on metal casting then, since you obviously know so much.