This NC30 carburettor could use some cleaning. Jets were incorrect. It contained more errors from a previous treatment. Insite it is like new now with all little rubbers replaced.
Пікірлер: 9
@jh-tech55462 жыл бұрын
Nice job! I assume the viton set is from LiteTek? Did youse any form of grease (silicone or other) on these new o-rings when assembling?
@NC35Race2 жыл бұрын
Yes, it is a LiteTek set. A little bit ATe grease (the same as for braking seals) See also this video: kzbin.info/www/bejne/mmG1mnt7hdtjrM0
@jh-tech55462 жыл бұрын
@@NC35Race OK, Thanks for the tip!
@jpdupreez3524 Жыл бұрын
Like the vedio good job. At whick height did you set the float height?
@NC35Race Жыл бұрын
6,8 mm float height
@jpdupreez3524 Жыл бұрын
@@NC35Race Thanks! That's from the float bowl mating face to top of float just before the fuel valve starts engaging ?
@NC35Race Жыл бұрын
@@jpdupreez3524 correct
@jpdupreez3524 Жыл бұрын
@@NC35Race Thanks. would you mind chatting over WhatsApp?
@NC35Race Жыл бұрын
@@jpdupreez3524 use my emailadres from the website: info@400v4service.nl