We miss these types of videos, BRING Terence back!!!
@maokinus4 жыл бұрын
Two apex enhancement ideas 1. add an adjustable delay interval (minutes 1-60) to every outlet for power monitoring 2. Allow for more customizable Trident schedules. Example set the Alk testing schedule separately vs Calc & Mag. #1 is needed as some devices take a few second boot up and there power usage might not be correct for the first few seconds/minutes. Without this my power monitoring causes a lot of noise but i keep on because it is a really important feature. #2 is needed as it always seems my Calc & Mag reagent runs out before my Alk. Allowing me to customize the schedule more would allow the entire reagent kit to be depleted around the same time. I believe this is key for accuracy and calibration. I have only been running my trident for 6 months and it seems my Calc & Mag reagent is close to exhaustion after my first Alk bottle is complete. As time wears on they will get more out of sync. I have been manually hitting the Alk button to use up the reagent more. Adjusting the schedule with the current options would increase the Calc & Mag tests and not solve the problem.
@Peltwerk4 жыл бұрын
If your going to be running a lot of smaller cycles wouldn't it be better to use the non relay outlets on the EB8 since they don't have a mechanical relay? Would they last longer then a switched relay?
@reefsentinel31104 жыл бұрын
Any chance in the future Australia can "Power Monitor" on a EB832????
@canvoodoo4 жыл бұрын
I am just about to set up my Apex El and trident. I have a D-D temp controller with a schego titanium heater attached. The titanium heater has no temp control of its own. Should I disregard my temp controller and just plug the heater into the energy bar 6.
@hishamebrahim5244 жыл бұрын
Is that mean I can't run my chilier at the orange Eb8? Or what ? Or must I buy another the black one? I m lil confused..thanks
@RailFanRick4 жыл бұрын
We can make live streams but we can't make 6 month reagent kits.
@PaulFraser49 ай бұрын
Hey team, My Apex isn't presently connected to Fusion, this has been all day and is absolutely unacceptable.