Рет қаралды 102,982
I'm upgrading the Mini Lathes drive and electric at the moment. For the new motor I bought a pulley which I thought will fit to the old tooth belt. But it doesn't and instead the new drive runs incredible rough and rattles crazily.
For this reason I planned to change the drive to Poly-V belt and pulleys as they run naturally smoother than tooth belts.
It isn't that easy to find the Poly-V belts in this small sizes. First I preferred the smallest profile PH but this isn't available in the right size so I had to change to the next bigger PJ profile. For this I had to make two pulleys which I show in this video.
I hope you enjoy this little episode.
Feel free to comment if you have questions or suggestions. And if you like the content, consider to like and subscribe :)
Thank you very much!
00:00 Intro
00:22 Making the bigger pulley blank
01:26 Making the smaller pulley blank
02:51 Testfit and little Poly-V excursion
03:39 Turning an arbor for further clamping the blanks
04:02 Finding the right tool for the V-grooves
04:26 Turning the V-grooves
06:02 Slotting the keyways
07:01 Final installation
Making a dial for Mini Lathes carriage: www.youtube.com/watch?v=8Ivp5... Adjustable Carriage Stop: www.youtube.com/watch?v=EpWPT... Mini Lathe compound angle modification: www.youtube.com/watch?v=rdkoT... Mini Lathe tailstock fine adjustements: • Mini Lathe tailstock m... - - Mini Lathe bearings for the compound slide: • Bearings for the mini ...