New holland disc mower, module trouble, bearing issues....

[@farmingforfunandprofit940]

There is the reason why I like the Krone Cutter bar....Power to each Turtle is down the rear of the cutter bar not from one turtle to the next in line, Krone has a video showing the assembly of the cutter bar........ We have 4 easy-cut 320s......

[@prima164]

In every youtube video talking about new holland mowers you're leaving the same comment. What are you crying about? If you have krones then why are you in every NH video having a hissy fit? Grow up cry baby.

[@prima164]

There's no way that bolt gets 135 ft lbs. If I snug that bolt down too much it will stop all the modules from spinning. Have had several NH mowers like these and they were all like that. Odd.

[@haycountry117]

That little 4 bolt hub with the bearing in it can you replace that bearing without buying that whole assembly. New Holland doesn’t show a separate number shows to buy the assembly but I would assume it would drive out. I got one disc with some bearing play

[@lewislifeoutdoors5189]

As far as I remember you are correct New Holland Doesnt offer a replacement bearing, always had to replace complete assembly, just seems right to do so anyway. However, you should be able to drive out, take to your local NAPA and see if the can match for sure, however you will probably damage the seal during that process. Just dont know if the "juice is worth the squeeze ". I would probably just replace assembly! Thanks for watching my video! Lewis Life Outdoors!

[@jackrawlinson5476]

never had that problem never check tension on bolt

[@lewislifeoutdoors5189]

I normally do not either, however after three attempts that is what fixed this one.