Love it. Nomad is great to work with! Another good build guys.
@nomadoutfitters6 ай бұрын
Appreciate the kind words Mark! It was a fun build with a lot of really cool one offs.
@airdowngearup4 ай бұрын
We were happy to be part of this! This build was great!
@nomadoutfitters4 ай бұрын
Turned out very clean! You guys did a phenomenal job on the cargo management system as well.
@mfreidbergАй бұрын
You have a molle plate on the drivers’ side exterior - was that a custom fabrication or did you buy it from someone?
@nomadoutfittersАй бұрын
Good morning, our client actually purchased that one and I'm not sure who the brand was. There appears to be a few options available for the side window molle panels. We did have to fab it a bit to work with the rear ladder.
@StefanBecker-j2x3 ай бұрын
Hi, great job, really impressive. Any support you can offer me to connect an ARB double air compressor with the Garmin Power Switch panel. I am struggling to find any wiring plan. Thanks for reaching out!
@nomadoutfitters2 ай бұрын
Good morning, power will go to the battery (you should have a couple posts in the engine bay but may need to run it directly to the battery under the passenger seat) and your purple trigger wire would go to the Garmin Power Switch. Let me know if you need more info.
@jeffengland81365 ай бұрын
What did you use as wiring channel down the A-pillar trim? It looks like a type of conduit that is perhaps fixed to the windshield?
@nomadoutfitters4 ай бұрын
Correct. On this one we made our own harness and ran a piece of conduit down the a-pillar. Depending on the vehicle and amount of lighting, we either do this or run 3 conductor down and use windshield glue.
@scotthutchinson21843 ай бұрын
Great build! Where under the hood did you mount the Garmin Powerswitch?
@nomadoutfitters3 ай бұрын
Powerswitch was mounted in the passenger side rear corner I believe. There was a good spot with clear access. You can see it around the 6:05 mark. Let me know if you have any other questions.