Nozzle Shell Junction Analysis using Hypermesh & ANSYS Part_1

[@swapnamuvvala7662]

hello sir. Its great.Ur videos are helping me alot

[@graspengineering9249]

So nice of you

[@rakeshpatil3723]

Thanks for sharing.. Amazing Content...Great Video..

[@graspengineering9249]

Thanks for watching!

[@Mxddydaboi]

good content sir

[@graspengineering9249]

Thank you !

[@种花家的小安]

Great content ❤

[@graspengineering9249]

thank you

[@shivprasad03]

Hello Sir, I am not able to import the file in to 3parts as shown by you. The number off parts created is more. Any suggestions will be appreciated

[@graspengineering9249]

Please refer part2, if you are following the complete vidoe then you should able to import all part in ansys as suggested inthe video.

[@srikantav4068]

Hello. Great content. I am new to HM and your videos helped me a lot. I am currently working on LS Dyna profile. Could you please tell me how to apply BCs, forces, displacements, velocities and pressures in this profile? I was asked to use curves to carry out an explicit analysis. I would be grateful if you could explain that. Thank you :)

[@graspengineering9249]

Thanks, you can go throng our HM tutorials for more details. We will try to upload similar video if possible.

[@santosht5790]

Hello sir, Please upload the geometry file as well even though its created in the earlier session. It will help us.

[@graspengineering9249]

Hello Santhosh, It is available in our blog for download. www.graspengineering.com/814/