NRCC - Mobile PA System

This is a video giving an introduction to North Ridge's new mobile PA system which we will be using for small outdoor events, BBQ's and church retreats.
The system consists of a 12 mono channel 4 stereo channel analog mixer, two stereo power amplifiers for left, right, monitor 1 and monitor 2. Each output channel has a 31 band eq for system adjustment. Also included is one wireless microphone, a quad channel compressor, CD player/recorder and effects unit.
Power comes into the rack via a Neutrik PowerCon connector. That is then fed into a Furman voltage regulator, this also goes into a rack mounted power conditioner on the front with lights.
If you haven't already, make sure to check out my new website dbbaudio.com for the latest news and updates!

[@beedslolkuntus2070]

Good setup, kind of amazing how one single digital mixer can replace everything expect the amplifier

[@DrewBrashler]

Thanks! I have had a few ham radio contacts from Croatia! Nice distance from my house.

[@davidmulandi8595]

Awesome esp for the power conditioner and power cone .

[@rokers45]

looks like a very good set up.. I am sure the sound must be even better ..

[@brettrobinson3960]

where can get a back panel setup like the one you have made?

[@1234588001]

hi thanks for the video i have 2000w xti crown amp i just want to use one 400w bin and one 300w top with eq and xover would the amp be to powerful thanks.

[@benjaminmyles5886]

cool setup man

[@bobbycampbell7094]

Love the set up.....but I have almost the same set up can I use one power conditioner for just amplifier an the next for equipments

[@vyizigirop.reeves6492]

Where can I find the back panel where the speaker cables plug Into??

[@arisvilladiego2404]

hey what type of connector did you use for the ac power the one that lights up and also what ac power supply are you using?

[@DrewBrashler]

Yup! I had the panel custom drilled and I installed them. Wiring inside racks is fun! haha

[@Tulwean]

that is a very nice set up

[@miket2885]

NICE SET UP

[@james100075]

Could you make a video on how the connections are made ?? right from the mic input to the speakers. do reply !!

[@jvchoer]

very nice system

[@fatv6608]

Do you have some that I can use zone input and control

[@frinkemon]

Love how about half of that rack space would be replaced with a digital mixer :)

[@WideFleurantus2020]

hey, i am building a rack and i would appreciate if you can tell me some of the thing that i need to put on .

[@BradCleghorn314]

Drew, given your experience with the x32, have you, or would you consider using Behringer's Rack or Core products in a mobile rig like this? Would love to hear your thoughts. It's budget season!

[@ravilall6575]

is it hard to wire that powecon setup im thinking about going that route

[@kayakbandits9894]

Whats the set up you have in the back where the power con and speaker connections are? Is that something you made or bought? I like it. My set up is very similar but yours is cleaner in the back with that power con thing.

[@thesage876]

How much a setup like that cost

[@charlschuck6]

For the mixer soundcraft have you guys tried the new model" digital version mixers its (soundcraft ui16) and how about yamaha mixers what rating you gove to those i recently saw a wifi all tech mixer from behnringer xr18 seems to be too good to be true but never have a chance to do a hands on testing. I went to sam ash and they denied me to test if before buying lol so i did not buy it..

[@jenniferarceo6667]

Sir what is use or meanthe compresor? Because i do nkow, thank for, because i plant to make a small set up for sound

[@djdave2299]

where u buy that case

[@joshakuma6381]

Hello and thanks for the video, please I would love to learn more and become better

[@HarmonicaMustang]

This is a nice video demonstrating your setup. Coming from a recording studio environment, I feel like a patch bay would be beneficial for an unexpected channel/outboard failure, as well as quick signal path rerouting. Do you feel like a patch bay is a worthy investment for such situations, or is it simply not worth the effort for the rack's purpose?

[@EdsilCleverOnline]

bro what is your power amplifier brand at the bottom of rock and how many watts is that?

[@leopaulevans7573]

hey new update to the rack the may be a dbx driverack or u are cool with analog eq

[@ramonafraser4356]

yo bro how much bass that equipment can push

[@Makibroz]

Nice.👍💖

[@TheVedran0705]

Nice rack ! Greetings from Croatia !

[@woods2190]

did you install the power, speak on, and 1/4 inch jacks in the back or did you buy it already made like that?

[@KertinaProduction]

It looks heavy. How do you load this?

[@tiagocardoso1924]

What's the brand and model of the "smart" plug? By the way realy nice rack!

[@JonathanZammit]

can you pls help me on this,i have 2 identical Power amplifiers EPX 2800 Behringer and when i connect the 2 amps together in parallel one of the amps is stronger than the other one,even the signal is stronger than the other on both full gain.i am using them on 8 Bose Bass bins 502 on 4Ohms.Thanks

[@tuneroneff]

the amp that is sending the signal to the nex amp it might have band sthit of, or limiter on and off. beringer are not tha good but they do the job just fine, if you know how to use them. hope this help!!!!!

[@seantroyer6003]

cod u make a video on how to wire it up

[@peterfrimpong5295]

Is it possible to work with you to build something similar to your set up if not the same set up. Or can I buy your set up? Please respond. I’ve been trying to get something like that. Thanks

[@alexgarnett19]

case model please

[@chrisdseverance5722]

What brand of rack is this bro? Awesome.

[@DrewBrashler]

redtortoiseTV Hey it was an EWI Tourcase from www.audiopile.net/

[@randypatotoy4659]

nice

[@789ghost342ghost]

case model please table is nice

[@MarcusWhybrow]

Looks exactly like the Rhino "Twin Table 16U DJ Rack Case" solutionsgroup-plc.co.uk/twin-table-16u-dj-rack-case/

[@quocgiaphunguyen780]

you will going to việt nam ?

[@ashimkashyap]

🤘

[@jaidon2435]

How much is it

[@jkprod.4314]

That probably weighs a ton!! But brilliant ...!

[@DrewBrashler]

+Jakes Khan Yeah it is a bit heavy with the two amps in there!

[@simoneto144]

Drew Brashler where can I buy the full setup? what's the total price?

[@grafxnrg]

That is not a PA System, its an SR System. PA=Public Address: Usually powered speakers for speaches, church or meeting halls. SR= Sound Reinforcement: Usually passive speakers for sound and music reproduction like bands, concerts and DJs.

[@BigHeartedMan65]

If you are thinking about building your own panels this is what you will need . 1 each 3/4 Greenlee Punch 1 each 15/16 Greenlee Punch Those will work with both the Male and female XLR's and the 15/16 knockout punch works with the powercons and speakon's .. If you are going to RIVET the connectors to the panels you will need a good riveter and you will use 1/8" Steel centered rivets. Drill your holes 9/32 I think it is , The Drill just up from the 1/8" . If you are going to Screw them on then you will need a box of 4-40, 1/2 Screws as well as the matching nuts with the star washers on them . You will ALSO Need a small Bottle of "BLUE" Locktight . When putting the screws and nuts together put a small dab on the screw and tightin them down . BLUE LOCKTIGHT can become your Best Friend in the WORLD .. Have fun And God Bless ....

[@afterthefox7]

Uhh Where are your SUBS?

[@kitchentable1362]

Have you ever seen anyone plig the powerkon into a speakon plug, running city power into speakers to destroy them? Seems like it moght happen if somebody doesnt know what theyre doing

[@benballard7521]

That can never happen as the powercon plug design is completely different to the speakon design. Have a look at Neutrix website for more deatails

[@afterthefox7]

some speakons have 1/4 inch built in. do your research.

[@anthonyjones6444]

Just buy yourself a drive rack it will save you the space and more importantly your back!

[@shanavasvv3385]

anthony mccain

[@TheSun_89]

It's a nice setup but you say 'uh' and 'um' too much man, perhaps think about what you're going to say before recording? Sweet setup though

[@charlschuck6]

He was pretty good and he should alot in s few minutes!!!

[@tonylackie]

Um...the....um...video...was...um....good...um

[@romaverynicekolkattawb1638]

a

[@afterthefox7]

never have two surge units plugged into each other. do your research.

[@dougtaylor7724]

afterthefox7 show us how you did your setup. Very interested in different ideas.

[@afterthefox7]

@@dougtaylor7724 I didn't plug two surge units together!?

[@afterthefox7]

@@dougtaylor7724 I used the Surge-X SX-1115-RT the best around surge unit and a cheap ole power strip from the drug store.

[@rikirex2162]

speak on on power and speakers...hope u just drink water at the gigs....