NX11 Video 2 - Using Datums

[@smokeypillow]

At 3:30, why did you set the diameter to 0.29” when it’s meant for a 0.25” fastener?

[@devarshivyas]

Or simply 1) create cylinder {Design Feature> create cylinde} 2) create mid point between two cap {by going curve > Point > between two point , select top and bottom circle center) 3) Project it on cylinder... And Voila... You have your design intent built in the model..

[@javierlizarazu796]

¿Es posible poner el traductor para Español?,para mi es muy interesante pero tengo problema de idioma