O2 Sensors | Replacement | 2012 Ford escape

Thanks Stopping by and checking on my channel thank you to all the new subscribers and all the old subscribers I’m going to keep pumping out videos get a light, and subscribe and leave a comment of what you thought of the video down below✌🏿

[@dawnjames3089]

Bro, you got that beard going on, man. That is a good looking bear, dude, I grow a Gray go tee, I'm 58 but man. Your beard's looking good man. You should be proud.

[@h.a.bgarage1008]

Thanks

[@just_ittybittybritt854]

Good job!

[@h.a.bgarage1008]

Thanks

[@Professordee94]

Where did u get the wrench from?

[@ahmedfarah4094]

Did u change banka 1 sensor 1 or the other ones

[@h.a.bgarage1008]

Yes I did that in a later date off camera just because the Check engine light came on after I replace those two

[@ahmedfarah4094]

@h.a.bgarage1008 u think I can access that and change the engine oil with out it without raising the car.

[@h.a.bgarage1008]

I wouldn’t suggest not jacking up the car if you’re going to be changing the oil because it stinks when it gets on your clothes and it burns when it gets in your eyes speaking from first-hand experience I did not jack up the car for the O2 sensors just because I knew I could get to them without doing it but doing it with a oil change is not safe in my opinion

[@ahmedfarah4094]

@@h.a.bgarage1008 thanks mate

[@migjesse20]

What was the part numbers you used?

[@h.a.bgarage1008]

This one too

[@migjesse20]

What code did you get?

[@h.a.bgarage1008]

If I’m being honest I can’t remember off the top of my head I just know when I scanned it my scanner gives me the code and then I’ll look the code up and get the part but if I can find it I will Let you know on both of your questions