Omtech Pro Co2 Laser - Dialing in Wood Cut Setting and Cutting Stupid Stuff

[@ttg5291]

Thank you for that. I just ordered the 2440 pro. Can't wait and hope that the quality is as they advertise.

[@BeardedBuildsCo]

Nice! Were you able to apply my affiliate/discount code?

[@MSRWorkshop]

I would be curious to see how much better that would look if you upgraded your air assist to compressor unless you already have for this video

[@lancenguyen9175]

Thank you for the great content. Are you using the autofocus from the control board on the machine, or using lightburn to autofocus? Thank you so much.

[@Messic0]

What are the settings in the remote?

[@ttg5291]

I totally spaced on that. There was a pre-ordered discount that was applied. Not sure if they would have discounted more or would they have?

[@ChaseFabbed]

Cut some sheet metal! that's what I'm excited for.

[@KWANTlZE]

its a gimmic

[@RobertBrady-g2v]

Do you think the Pro 100 is better than the AF3555-130 130 watt

[@F1v30h1]

How is the engraving quality on the 150w? Looking at picking one up but what it seems the higher watt poor engraving. We are doing like 50/50 on engraving and cutting. This type of information is hard to come by.

[@eian31]

Are you running stock air or a compressor?

[@tobymay31]

Surprised you were able to use lightburn on this model. It wasn't a listed option for this unit on the OMTech website.

[@BeardedBuildsCo]

It has worked perfectly from day one. You just have to install the trocen specific drivers before using Lightburn.

[@jackyoung6387]

Does this only work for Windows PC? Does it do Mac?

[@ttg5291]

Do you happen to know the max z height? Appears to be missing from the specs.

[@BeardedBuildsCo]

I measured it the other day. With the bed as low as it goes measuring roughly from the focus point down to the knives there is about 9 inches. If you needed more than that you could remove the knives and go all the way down to the catch tray.

[@1-Nice-Guy]

Nice! I never thought about circles vs. squares in testing...excellent! Does the Polar have a red dot for framing?

[@chrissmith-wq6gr]

Compressor air assist would help cut a whole lot better.

[@craigromero5921]

great information

[@johnthompson5388]

Great content

[@mjethier]

Shall I assume this is an early access product to you only? I have a 4063 unit...this pro line is miles ahead of my 4063.

[@BeardedBuildsCo]

Yes, this has not been released yet but coming very soon.

[@TheJohnny3d]

What was the minimum settings? Because it is important and you never mention this why?

[@BeardedBuildsCo]

What settings are you talk about?

[@KowalskiDoes]

$13k machine $5 microphone Good video. Get a wearable mic! 😂🤣🤪

[@BeardedBuildsCo]

The fans are the problem

[@vonellis4654]

@@BeardedBuildsCoalways a smart a§§ in the bunch