On delay timing control circuits

[@danishrahman-pm5xj]

Very nice ❤❤

[@ヘスラーセン]

a well thought out explaination

[@salsal1967]

Hello Thanks for the video. Can you help me on the following: I have 2 Air-conditioning units which I don't want to have them turn on (takeoff) at the same time as if that happens the main circuit breaker switch trips. Therefore I need some sort of a delay-On device that receives signals from the two thermostats of the two AC units and then pass them to there assigned magnetic contactors one after the other with a time difference between the two to prevent the units from turning on at the same moment which will lead to MCB tripping. Waiting for your valuable answer. Regards, .

[@aboalhassenahmed7270]

The auxiliary coil M How it will hold if it in normally closed ? I think It will be in open state ?

[@tg9507]

Very informative. I’m a woodworking guy, and a novice in electrical automation. I am trying to automate my shop vac filter cleaning. I have a 2kw 220V shop vac, and a small 200W motor that runs the filter cleaner. I start and stop the shop vac with a remote controller. Today I run the shop vac filter cleaner manually. I would want to run it automatically with a time delay, such that it starts 5 sec after shut down of shop vac, and runs for 10-15 sec, and then shuts down. This repeats after each time I use the shop vac. Do I need a full set of interlocking contactors, relay and timers to ackomplish my goal? Can you guide me, or better still, could I ask you to create a KZbin video on this topic, as I am sure I am not the only one struggling with this task.

[@pelicanman2315]

Greetings to you sir. Great tutorial. Can you do two of this circuit in one so that when one motor stops, the other starts? 3 phase.

[@mrwega44]

if i remove the contact M and keep the timer will the timer still count 5 seconds if i press for 1 sec i will be left with 4 seconds or will it restart waiting for a continuous 5 seconds

[@aaronflores5659]

Dont you need a cr1 to hold the start in place? Or does the time relay hold the botton closed?

[@ushaandusha]

You are technical but not clear may be you should have a better video