Onewheel custom underglow install (WIP)

Part II taking it to completion is here...
• OneWheel Custom Underg...
Here is how I went about installing underglow on my onewheel. It is work in progress, as I still have to epoxy the LED strips for protection, and will likely continue the strip along the length of the rails.
I coded the light sequences onto a teensy 3.0 since it is quick, but will likely transfer it to a barebones ATmega328.

[@robertcb2005]

This is awesome. Planning to add this to the gt

[@Rambl3On]

Nice Job! Super clean install!

[@mohawkpiper]

hey thanks! i was able to finish it a few months ago and it is pretty sweet. it runs the full length of the board. maybe i can get a new video up sometime soon. if so i’ll point you to it

[@Rambl3On]

@@mohawkpiper that’d be sweet! Love to see how it looks!

[@mohawkpiper]

@@Rambl3On here you go kzbin.info/www/bejne/fqLPfWl6erVrqtU

[@isiglz]

Cleanest lights I’ve seen on a onewheel, have you gotten any damage to the lights before?

[@mohawkpiper]

no damage yet. still havent even covered them with epoxy yet and the plastic covering hasnt been on since i pulled it off in this video

[@chasekasperowski8253]

Noice