Opel Corsa Engine Overhaul Part 2

[@grantwilliams8501]

would have been nice if the torque specs were included

[@phiwetshona9091]

What are the torque settings for the crank shaft?

[@mlekelelimichael2686]

Nice video please make more of this angene👍

[@solveitautomotive9485]

Thanks man . What would you like to see?

[@dawnnyoni4250]

We really appreciate your videos man,dont mean to sound funny bro,but may you please invest on a better camera, the current one has bad focus and zoom...keep up the good work,your follower for life

[@dalconiamogolegeng6639]

Afternoon Sir, can I please have the main bearing torque for the crankshaft.?.

[@bennetbrooks1]

Thank you for your videos. Where do you buy your parts from?

[@solveitautomotive9485]

Hi. Depending on what part is required, Masterparts, Suburban, Alert, AHK and Goldwagen

[@bennetbrooks1]

Thank you.

[@herbertleon326]

Hi if the cambelt slipped off will it bend the valves. Belt not broken opinion please how much gap between the valves and pistons???

[@gustiedupont6339]

Hi I have a 7W Opel Corsa 1.8 engine. I want to build it up. How much will the cost be to engineer al the parts. I like your program and will be asking more questions.

[@bennetbrooks1]

Which engineering company did you use?

[@sthabisomdunge3303]

How can you be reached sir where are you staying I have lot of problems with my Corsa gamma very less people have knowledge about this car

[@josephmandla1288]

What is the torque and torque sequence for the cylinder head bolts?

[@solveitautomotive9485]

Hi 25 newton meters 60⁰ 60⁰ Wait 10min 60⁰ Torque from the inside out. You can google the sequence diagram. Make sure your bolt holes are blown out and clean. Use new bolts.

[@josephmandla1288]

I'm currently working on a Chevrolet utility 1.4i Is the torque the same ? because the engine is still the same as the corsa.

[@sthabisomdunge3303]

How to clean a throttle body

[@Mandla_eze_GMazai]

You should relocate to Joburg 😅. Id bring my car to you all the time, this bush mechanics we have here are horrible unprofessional people.. Good stuff

[@robmoody371]

What reasonably priced OBD scan tool do you recommend. I have tried ELM 327 and OPCOM and neither seem to work

[@mervinjoseph3031]

Hi I do all that in your video but engin still has a lack of power?

[@solveitautomotive9485]

Hi , when u say lack of power what do u mean.

[@mervinjoseph3031]

Hi it stalls and cut of

[@mervinjoseph3031]

Cut out

[@mervinjoseph3031]

I have changed timing gear and pully crank sensor mash air,idle plug wire, coil,trottelbody sensor you name it but still no power

[@02Muzi]

Which engineers

[@bennetbrooks1]

Was your cylinder walls honed or bored?

[@solveitautomotive9485]

The cylinders were bored. First bore from standard

[@colindavids37]

I just wanna know i hav the exact same enjin , can u tell me if the parts like big ends bearings and rings are standard ??

[@solveitautomotive9485]

Are you asking a new question, cause I did respond to you in the other post.

[@mazarkhan4997]

India.mangl00r.bagpe