Overview of a DIY combination airbrush and laser enclosure for NEJE Master 2s Max

[@agarza6475]

I just recently purchased a laser engraver and previous had been thinking about an airbrush booth. I have seen the same portable airbrush booth you are using. This build gives me some great ideas about how I want to go about building my airbrush/laser engraving booth. Thanks for sharing your success!

[@reedinspace2286]

I'm really glad you found it useful. Good luck with your build!

[@KatherineSandersis]

smart way, very impressived!

[@markferrick10]

Very nice. Thanks for the tour.

[@John-of5sh]

I should have paid more attention. I see now that you 3 D printed the riser blocks. Again, Thank You for sharing!

[@reedinspace2286]

Hey John. Not a problem and I appreciate the feedback! Good luck on your project.

[@John-of5sh]

I have looked at many different enclosures plans on You Tube and IF I was building one today, I would try to make it look just like yours. Very well planned and a very clean looking design. Unfortunately I already spent all my money on accessories for my laser and the price of plywood is scary, so this will have to set on the back burner for a while. Thank you so much for the plans and attention to detail as well as your time! I do have one question, what material did you make your black riser blocks out of? Again Thank You Sir for sharing your time and wisdom! John

[@alessandrosuppini943]

Nice build, where did you put the air intake for the 4” vent at the top? Are you just relying on air gaps around the door?

[@reedinspace2286]

Thanks! Yes, there are plenty of gaps in my design for airflow. Both planned and unplanned. Lol!

[@LavinWoodworks]

How is the air brush compressor doing for the air assist?

[@reedinspace2286]

It’s ok for short cuts. Maybe anything less than 10-15 minutes but it gets pretty hot after that. I do need to upgrade to something that can run longer.

[@mattbyman]

Thanks

[@neaglestyles9305]

thats great

[@giuseppeabbondanza5250]

Ottimo video.. complimenti! Potresti inviarmi i parametri grbl digitando nel pannello comandi (💲💲)?Mi faresti un gran piacere😊