Package Unit Acting Up After Replacing Heat Exchanger | HVAC

[@carlsmith5919]

That's the sign of somebody who takes pride in their work. There is very few of us out here who will still do the right thing and will not stick it to the customer. Don't change young man don't change.

[@AB_HVAC]

Thanks a lot 🙏🏽

[@HVACKR]

you did the right thing and figured it out. bravo, sir!

[@AB_HVAC]

Appreciate that ✊🏽 definitely was second guessing for a minute

[@HNIC86]

You did right my bro good job awesome content once again

[@AB_HVAC]

🙏🏽 Thanks for the support

[@ccthepope]

Great video!

[@AB_HVAC]

Thanks for watching!

[@alfonsohernandez2384]

Good job !!!

[@zekenzy6486]

Great video. Thank you for sharing

[@aj_44bell]

Good work big bro

[@joemartinez-673]

Thank you 🤟 😎

[@AB_HVAC]

✊🏽

[@rossflores4394]

Don't beat yourself up too much bro I've been doing this for 25 years and I still run into crazy issues like that

[@AB_HVAC]

Appreciate that 🙏🏽

[@PaulZ154]

Those control boards are bad about the solder points on the back of the eight pin connector breaking/cracking. I replaced those boards a bunch of times for that exact same reason that you had.

[@AB_HVAC]

I knew there was something wonky about these dang boards

[@MichaelScott000]

🤘🔥

[@AB_HVAC]

✊🏽

[@patrickbell4687]

I'd blame it on the lizard also!!

[@Paul-IE-Repairs]

those needle probes have a bad case of rickets

[@RidingWithRamsey]

I Would advise them to fix their duct issues because that most likely caused premature failure

[@jkmarshall3553]

Crusty Lizard trying to foil your repair and make you feel like a tool. 🤣 Actually, you did a great job with the fix given all those twists and turns!

[@AB_HVAC]

The worst part would've been if the system kept working after removing the lizard i don't think the supply house would've let me take the board back because I broke the seal on the package of the board 🤣

[@jkmarshall3553]

@@AB_HVAC A little spray adhesive would bring that packaging back to new. Allegedly. 😁

[@AB_HVAC]

@jkmarshall3553 🤣 allegedly

[@john7017]

Cut back on the gas pressure after coil cleaning to get temperature rise in specifications.

[@AB_HVAC]

The specifications on that dataplate state 40-70, I was st 60 about 2-3minutes before the system satisfied indoors. I agree it's dumping out A LOT of heat but it doesn't seem to be causing a problem right now. I'll notate it on the invoice though on our end so if we get sent back out we can check it