Pard DS35-70 LRF Update of Firmware - Zoom & Adjusting the LRF with testing

[@roberthowe2910]

Don t know if it changed fir gen 2 ds35..but my ds35.gen..1..u adjuster lazer marker followed your dot..so u did.nt adjust any screws etc....

[@andywarren1327]

Looks like you could use way lower scope rings... she's right up there!

[@lankey21]

Hi what site did you get the latest firmware update from for the magnification Thanks

[@LRHVerminControl]

It was a Pard official site don’t remember the exact address but google it was easy to find and works much better thanks 👍

[@benbaker818]

Pard have given us the update for 2x magnification and they say they do such update for 4x magnification. Do you know where to find the one for 4x magnification

[@LRHVerminControl]

Just google pard ds35 update and you should get a list of available site

[@benbaker818]

@@LRHVerminControl are you able to send me the update file over email?

[@LRHVerminControl]

@@benbaker818 yes i think so still have the file on my computer if you email me using my email on my youtube channel home page ill try to send it

[@nimrod260rem3]

Hi mate I have the original ds35/70 so I’m guessing it’s a mark one not a 2 I’ve tried the mag upgrade and it doesn’t seem to work, do you know if its because it a mark 1 dose it make a difference 🤔👍

[@LRHVerminControl]

I don’t know but i thought the only difference between the mark 1 & 2 was the ir torch ? So I would have thought it would work ? Maybe try again and make sure you have everything set up correctly???

[@nimrod260rem3]

@@LRHVerminControl yes you have a point there, that’s what I thought was just the ir but not sure I did try it a few times and followed instructions! Thanks for replying anyway 👍

[@Nightfox456]

Much better now

[@bamoore65]

I'm computer stupid. What are the steps I need to do to install the firmware upgrade? Thanks in advance

[@LRHVerminControl]

Go to the Pard website and download the new firmware onto your computer for the device-DS70 Remove the SD card from your Pard DS70 and make sure it’s clear of anything then add the firmware update to the card (drag and drop) Then put the SD card back in the Pard DS70 and switch it on I think from memory your see the red led light start blinking fast when it stops the update is done it also reformats and clears the SD card so your ready to go 👍

[@bamoore65]

@@LRHVerminControl does the sd card have to stay installed in the scope after downloading? Thanks again with the help and videos.

[@LRHVerminControl]

No it downloads to the scope memory you can use any sd card after