PARKSIDE Angle Grinder PWSA 20 Li-B3 Brush Motor Fail and Repair (X20V Team)

[@ErCanEverything]

👇👇👇Subscribe to my channel👇👇👇 kzbin.info

[@terraverdeitalia]

Great video. Are available only carbon brushes?

[@MisarGaming]

how did you fixate the back end of motor housing, did you weld it or anything else? Because i see that you have grinded away old bits

[@nofunclub]

Mine has a burned transistor on the main board and I can't read the type number on it In order to do a repair I need to know Can you help me ?

[@ErCanEverything]

Of course i can help you🙂 I took a picture some time ago and I have it on my phone. NCE40H12

[@nofunclub]

@@ErCanEverything one million thankyous

[@ErCanEverything]

I'm glad if I was able to help you🙂🤝

[@WujaBartas]

how did you stick these brushes to this plastic?

[@ErCanEverything]

I soldered them underneath with 2.5mm copper wire, and glue them together.

[@gotzolones]

In my grinder just like that one, PARKSIDE PWSA 20 Li-B3 speed has broken down. The speed regulator does not work, even if you go up or down the speed wheel it always goes to the maximum. I don't know how to fix the problem. The NCE40H12 40v 120A mosfet was changed for a new one.

[@ErCanEverything]

Maybe after the mosfet burned out, it also damaged the control driver. I need to open my angle grinder to see the whole board and think of something, but I don't think it will recover🤔

[@memutu]

hello, what s the motor code if you please. Thank you!

[@ErCanEverything]

Hello. The original Motor code is: "PARKSIDE speedmaster RS897-20V" But I mounted the 895, it is low speed and its performance has dropped. The motor you buy must be 20 000 RPM

[@ErCanEverything]

kzbin.info/www/bejne/jZi8doiXaNKbm6M

[@memutu]

@@ErCanEverything thank you very much!