Here I'm fitting the main crank seal and torquing down the dual weight chromoly flywheel with a chromoly 38mm racing nut. All very standard stuff until you realise your torque tool is for a 36mm flywheel nut.
Пікірлер: 17
@johnfreeman11892 жыл бұрын
Good stuff! Thanks for posting.
@aircooledanything24152 жыл бұрын
You’re welcome.
@mikehammer45462 жыл бұрын
Nice, no problems 👍
@aircooledanything24152 жыл бұрын
Thnaks Mike. No problems apart from forgetting to record the most important bit of the process hahahahaha.
@jamesaschebrock11862 жыл бұрын
@@aircooledanything2415 where’s the next video?
@aircooledanything24152 жыл бұрын
@@jamesaschebrock1186 working on one tonight. Should be up tomorrow evening. Sorry for the delay.
@dart9sales9012 жыл бұрын
Hi, I hope everything is ok Been missing your video updates for a while, Frits the Netherlands
@aircooledanything24152 жыл бұрын
Thanks for the words Frits. Just posted a new vid this evening. I'm backin the saddle and I'll try to upload more regularly.
@ethandomantay49262 жыл бұрын
Where can I get buy that hat? I love it!
@aircooledanything24152 жыл бұрын
Hahahahaha, it's from Bolt Motorcycles London, but I don't think they sell it anymore.
@vintage76vipergreenBeetle2 жыл бұрын
👍
@prkid4242 жыл бұрын
How did you calculate the end play of fly wheel? Been looking at your videos and didn’t see where you did that. Great video series!!!
@aircooledanything24152 жыл бұрын
Hi! I did indeed post about flywheel end float. To be honest I;ve not made a great job of ordering or editing the posts.I;m just doing it as I muddle along. I think what you're looking for is here. kzbin.info/www/bejne/b3nJh5SjqMefpKc&ab_channel=AirCooledAnything
@aircooledanything24152 жыл бұрын
I used a dial gauge indicator. Once on a test fit and then again after I’d buttoned down the short block.
@charliemessenger65372 жыл бұрын
I looked up a multiplier for VW’s and I wonder, are you using the correct starter voltage gear? The ones I saw came with a 6v and a 12v gear. Could that be the slippage issue? She’s stating to come together now! Oil cooler, gen stand then tins etc. You’re in the home stretch now!
@aircooledanything24152 жыл бұрын
That’s exactly right. The tool comes with two gears. One for 6V and one for 12V flywheels. You swap them in and out of the tool for the application you require. You also get an arced plate with corresponding teeth that you can use to tighten and undo rear brake drum castle nuts. Which is very handy when it works. I was definitely using the correct gear from both tools - one worked, the other didn’t. I guess I was unlucky and had a badly made tool. Yep home stretch. I hope to post more regularly.
@charliemessenger65372 жыл бұрын
@@aircooledanything2415 Yay! More videos! Gimme gimme gimme!!!