AZ Is a great site for tottal replacement. But this is the video I have been wanting to see
@hillbillyrv3 жыл бұрын
Thanks. Glad you like it Terry.
@vnch19542 жыл бұрын
Az
@Rackpack-mb4ml6 ай бұрын
Great video! Have 2 hail holes from baseball size hail i have to fix on my jayco. This is exactly what I needed to see
@garyhartle75333 жыл бұрын
Cut a circle for a patch then nothing will lift after you roll it out. Also dont use sheet rock coarse screws. Use stainless steel
@hillbillyrv3 жыл бұрын
Thanks Gary. All good ideas
@virginiareeder99614 жыл бұрын
Pro patch...
@hillbillyrv4 жыл бұрын
Thanks. We try
@user-ki5hp1ng4nАй бұрын
my satellite dish hole has been repaired with a metal plate, are there negatives?
@agent8699Ай бұрын
How big of a hole can be patched this way.
@hillbillyrvАй бұрын
I have done 3-4 feet before.
@thinkford3 ай бұрын
Then ad a solar panel on top of that for even more protection!
@hillbillyrv3 ай бұрын
Oh yes. Put even more holes in the roof.
@thinkford3 ай бұрын
@@hillbillyrv Was thinking flex solar with tape and sealant
@robertthompson69584 жыл бұрын
Generous of you to give a shout out to AZ rv repair. I’ve watched many of his roof replacement videos. Wouldn’t insurance authorize the full replacement of this roof? Two thumbs up. Enjoy your channel.
@hillbillyrv4 жыл бұрын
They did. The customer got a NICE fat check, but opted to patch it. That is their decision. I just do what they pay me to do. Thanks Robert
@rayraycthree57842 жыл бұрын
I would cut the patch first then trace it on the roof. Cutting the eternabond patch corners round would seem to reduce possibility of corner pulling up
@hillbillyrv2 жыл бұрын
Good ideas.
@donklaing2 ай бұрын
You just left the Eterna bond backing on your first patch? Then applied the final patch over a dirty surface. You will be re-visiting this job soon.
@hillbillyrv2 ай бұрын
I have learned a lot in the 3 years since this video was shot. By the way, I never heard from them, so it must still be ok, 3 years later.
@thehomesteadpastor12343 жыл бұрын
Man. Nice. I’m Loving this channel. Probably one of my favorites. Great Job.
@hillbillyrv3 жыл бұрын
Thanks so much Trey
@marcuscarmouche90233 жыл бұрын
I agree well put together channel keep up the good work as an rv tech myself I like watching other’s troubleshoot and figure out problems
@hillbillyrv3 жыл бұрын
@@marcuscarmouche9023 Thanks Marcus. That means a lot to me.
@marcuscarmouche90233 жыл бұрын
@@hillbillyrv your welcome well deserved
@covetthecamper22893 жыл бұрын
Gets the job done. One step further would be to go over the edges of the Eternabond patch with self leveling sealant. Either way, a good repair.
@hillbillyrv3 жыл бұрын
Thanks
@AustinMccathern-i6u5 ай бұрын
Looks like ita work thanks for video and advice
@hillbillyrv5 ай бұрын
It must have worked. This was 3 years ago and I haven't heard from them.
@howardsternssmicrophone93324 ай бұрын
I have a talking dog. I asked my dog "What's on the top of a house?" and he answered "Roof!". Then I asked him "How does sandpaper feel?", and he said "Ruff". No joke.
@hillbillyrv4 ай бұрын
Wow !!! You should take that show on the road.
@donjackson21292 жыл бұрын
You need to be using a flat square and a multi tool there could be wires underneath of that
@hillbillyrv2 жыл бұрын
Sometimes you just have to live dangerous.
@markevans35893 жыл бұрын
I'd have cleaned that roof more, but it was a good repair and video! 👍
@hillbillyrv3 жыл бұрын
It's hard to clean off years of tree sap.
@richsmith90635 ай бұрын
You're supposed to make the Brake Clean sound when the can is shown ....
@hillbillyrv5 ай бұрын
I am not Eric O
@laundrymanadams61052 жыл бұрын
I guess it did not go all the way through, I see you and I have the same issue with shacking hands, stops me from painting as I put more on the trim work then walls. Good video my friend
@hillbillyrv2 жыл бұрын
It sure didn't. It didn't even touch the ceiling panel.
@timdungan2092 Жыл бұрын
What did you use for the actual patch material?
@hillbillyrv Жыл бұрын
1:06 I say I will use Eternabond 11:00 I show rubber filler in hole 14:12 I show Eternabond package 15:09 I glue rubber filler down 15:49 I put Eternabond patch on I kinda think you didn't watch the video....ha ha
@YAHaqabNatsariym27014 ай бұрын
He mentioned using osb board early on briefly
@kristenpearson51502 жыл бұрын
Any suggestions on closing the space from removing the water heater? I’m thinking it’ll be a little like this just bigger. Thank you for any suggestions!
@hillbillyrv2 жыл бұрын
It will be really tough to close that hole, if you want it to look really nice. If that is not too important, just get a small sheet of aluminum in the correct color. Put that over the hole and seal it with silicone.
@marcuscarmouche90233 жыл бұрын
Just curious have you ever tried welding a patch with pvc glue. Mostly the same way you done that one except using a square of roof membrane and pvc glue to chemically bond the seams
@hillbillyrv3 жыл бұрын
Nope. Never tried that.
@JerryLynch24 жыл бұрын
Mama's rolling pin would of layed that patch out, too! But it would have gotten you into a pretty good fuss, Lol! Nice job fella's!
@hillbillyrv4 жыл бұрын
You know better than touch mama's rolling pin. lol
@kennethschroeder27892 жыл бұрын
Where can you order the eternabond sheet. Thanks, Sacramento
@hillbillyrv2 жыл бұрын
There is 4 inch, 6 inch and 12 inch wide Eternabond in my Amazon store. www.amazon.com/shop/hillbillyrv
@TomAllenBird2 жыл бұрын
Thank you for this video! You just saved me a TON of money!
@hillbillyrv2 жыл бұрын
You are welcome a TON
@OmarLake-s6q6 ай бұрын
WOW instant relief! Thank you!
@hillbillyrv6 ай бұрын
Glad I could help.
@TC-tw5zk4 жыл бұрын
Nice job!
@hillbillyrv4 жыл бұрын
Thanks Tom
@ianwilliams62943 жыл бұрын
great video. where can i find an eternabond patch that size?
@hillbillyrv3 жыл бұрын
They make eterna-bond in wider widths and you just cut the size you need.
@Ricky-eo5ym9 ай бұрын
Nice 👍
@rjohnson37602 жыл бұрын
Thanks!
@hillbillyrv2 жыл бұрын
Very generous...you are welcome
@tonyoliveri87083 жыл бұрын
Prior to the Eternabond patch, what material was that smaller patch you put on the wood first?
@hillbillyrv3 жыл бұрын
Rubber roof material, just trying to make it all the same thickness. Make it look as good as possible.
@tonyoliveri87083 жыл бұрын
Thank you!
@michaelcanto61752 жыл бұрын
NICE
@sandrawoodcock25223 жыл бұрын
Awesome video. A lifesaver. Thank you.
@hillbillyrv3 жыл бұрын
You are welcome Sandra
@lonnie46797 ай бұрын
Thx for video good one
@hillbillyrv7 ай бұрын
You are welcome
@markevans35893 жыл бұрын
No dicor around the edges?
@hillbillyrv3 жыл бұрын
I think I did, but for some reason didn't have video of it. Good catch Mark