PCP Airgun: Walther Dominator 1250 Cal. 6,35mm (.25) & Powerupgrades Part 2. The Regulator

[@davidwoodward7020]

fascinating video,would this work for a walther rotex rm8?im guessing theyre bascially the same gun?and what was the improvement in statistics you made?fps or ftlb energy etc...many thanks,david

[@Nurzhan301]

Thank you for such an interesting video! Would be perfect to see chrony results and comparison between two reg settings. What do you think my Walther Domi 1250 brother?))

[@ODOG079]

You're welcome, bro! Thank you very much :-) Like your idea. Maybe I can do something like that around March 2014. I really hope, that I get my stuff back after my public trial. Greetz, OD

[@alialian8857]

Hello I would like to restore the screw size2.5 to the factory settings What are the way

[@maxx2603]

Hallo, Weißt du was der Unterschied zwischen dem 7,5 & 16J Ventil ist ? Ist die Feder schwächer bei 16J und was ist am Hammer anders ? Danke

[@alialian8857]

Thanks to the video Is This method is useful with size 22

[@ODOG079]

Ali Alian Hello Ali, thank you :) Yes and No. It is useful in .177/.22/.25 Cal. if you know what your doing... If not, leave the Regulator alone. You can run into some problems. Trust me! Greetz, OD

[@alialian8857]

Hello I would like to restore the screw size2.5 to the factory settings What are the way

[@ODOG079]

Hello Ali, sorry, bro'. I was busy... That's not easy. You can do it the hard way and adjust the regulator in steps: 1. tighten the regulator screw to Maximum 2. then loosen the screw a 1/4 turn, assemblage and reseal the regulator and check with a Chrony the fps or m/s . Not happy? Then 3. disassemble the regulator, loosen the screw again about a 1/4 turn, assemblage and reseal and check again for fps or m/s. 4. Not happy? Then do step 3. again with another 1/4 turn... I know it's a pain, but I warned you before! You can also build a pressure gage with a pressure indicator which fits to your regulator. But that's a lot of work, too .... Best wishes, OD

[@crusader6719]

tolles video. könntest du es auch nin deutsch syncren???

[@ODOG079]

+Memento Mori Hi, da muss ich mal schauen. Vielen Dank für deinen Tipp :-) Wenn du Fragen wegen der Übersetzung hast dict.cc oder mich ansprechen. Gruss, OD

[@fabianrapp-ek6vv]

@@ODOG079 hallo wie kriege ich das in deutscher Sprache?

[@alialian8857]

Hello Is this the regulator valve work

[@ODOG079]

Ali Alian Hello Ali, yes you're right ;) Regards, OD

[@alialian8857]

tanks

[@ODOG079]

Ali Alian You're welcome!

[@gerdstoiber]

​@@ODOG079 hallo stimmen die Einstellungen der Wurm Schraube vom Regulator auch bei der 40joul? (1mm 15bar) Bzw was ist wenn man die Wurm Schraube komplett raus nimmt? Mfg aus österreich