Peugeot 3008 DPF additive tank replacement and refill...

Consider to support my channel and all the hard work put into it at / lmautorepairs
Thank you
Hi
Following up from the last work done on this car, video here • Peugeot 3008 Airbag li... , on this video we will be replacing the faulty component... the fuel additive tank, refill it and reset the ecu...
We will be also changing the overall quantity of fluid programmed on the unit, from 1 litre to 2 litres...
Follow me on this video to see how it is all done...
Hope you enjoy the video.
Any questions or comments put them below.
Like always, thank you for watching!

[@kevinpalmer7452]

Very interesting 2 part video I’ve been in the motor trade 48 years and I can tell you this guy can hang with the best.

[@MrLekatt]

Completely agree!

[@LMAutoRepairs]

☺️ Thanks! Really appreciate your comment! 👍👍👍

[@MrLekatt]

Well done Luis, again! I watched both videos and I am, as always, amazed at how you always go to the bottom of the problem and restore the systems to OE specs. Thanks for sharing all the important details when diagnosing faults. 👍👍👍

[@LMAutoRepairs]

☺️ No worries!... Thank you for watching and for your comment! 👍👍👍

[@davejohn6261]

Another cracking video,keep um coming,thanks ,have a good day luis

[@LMAutoRepairs]

☺️ Thanks! 👍👍👍

[@richardkhoza2878]

You are very good with French cars

[@LMAutoRepairs]

😊 Thanks! But my French is terrible... 😅😅😅 👍👍👍

[@ibby_786]

Your a clever guy

[@LMAutoRepairs]

☺️ Thanks! 👍👍👍

[@amarabdelli487]

Thanks for sharing

[@LMAutoRepairs]

Thank you for watching! 👍👍👍

[@jackiemay9471]

GOOD MORNIG LUIS what a faf to fill the tank even if you use a big syringe pump

[@LMAutoRepairs]

👋 👍👍👍

[@daveperry2497]

Great video, for the P1351 fault, was that relay issue ir an dead plug?

[@mothanagharbe513]

I told you he would not believe 😅 Good morning

[@LMAutoRepairs]

😅 👍👍👍

[@beluxauto5968]

Nice Luis. That stupid clip on the fuel tank is a genius design🤣🤣

[@LMAutoRepairs]

I know...🤣 The French... 👍👍👍

[@sandrozabata4761]

G.morning ,cheers

[@LMAutoRepairs]

👋 👍👍👍

[@sebastienbethge5324]

Hi Luis , latest gen of 1.2 peugeot tanks are totally different but problem is the same 😂 , i was talking about those

[@LMAutoRepairs]

☺️ 👍👍👍

[@lukas181118]

Latest got 2 tanks , pat fluid and adblue ,both common for failure as f…

[@user-jg6vw3em9f]

Hi Luis. Great video once again. I recall from your earlier video clips that you mentioned you will not entertain fixing vehicles unless the parts were sourced from the car manufacturers or OEM. What's the change? Cheers 😊

[@LMAutoRepairs]

Nothing... I will accept second hand, is supplied by the owner... If anything wrong, I will just handed them over and they will deal with the hassle...☺️ 👍👍👍

[@sebastienbethge5324]

And i only did adblue tanks on 1.2 , those are the plagues i was talking

[@LMAutoRepairs]

Have not done those yet... 🤪 👍👍👍

[@anapaulapereira3255]

top

[@LMAutoRepairs]

😊 Thanks! 👍👍👍

[@autosport3081]

Great Job as always in both videos,but as a PSA Tech. you should of followed the instructions of the diagnostic tool,and went to the engine ECU to do learning of filling the additive,and then went back to the additive ECU and do what you did.

[@LMAutoRepairs]

Was no option to do it on the engine ecu... Because the engine ecu did not controlled the additive... as it was a separate additive control module... as I have explained in the video... I believe it is a bit of a messed up instructions on the software part... The instructions seemed generic for both options... 👍👍👍

[@cozmiccoz2195]

Hy! you, as a PSA Tech, will use the OEM software and that will guide you through the whole process ,depending on the car, but on ,not OEM software, the situation is different, as they can ask for things that ,as Luis said, are not required.

[@alanblack1333]

where is part 1 carnt fined it p.s thanks for this upload

[@LMAutoRepairs]

Link in the description of this video.. 👍👍👍

[@CarlosFerreira-lb5fu]

Excellent work! Did you had the "pleasure" to work with adblue tanks for recent diesel peugeots (2016++) ?

[@LMAutoRepairs]

Not yet... But I am sure they are out there awaiting for me...🤪 👍👍👍

[@CarlosFerreira-lb5fu]

@@LMAutoRepairs I will wait for the video! :)

[@LMAutoRepairs]

☺️👍👍👍

[@Fabi....]

Hi. I recently replaced such a tank and did not do the procedure for filling the lines. After a few refuelings, an additive leak error popped up. After doing the procedure of filling the lines (10 min), the fault did not return.

[@LMAutoRepairs]

☺️ 👍👍👍

[@korkira1]

Does P84 needs online coding?

[@lubelska17]

Can you tell me the pinout of the 3 cables in electric socket? I have same tank citroen C4 grand 2012.

[@LMAutoRepairs]

Power, ground and lin bus...

[@goodlet6431]

I do have Citroen C4 cactus with urea error still on I am told it's the pump. Do I need to change the whole tank or the pump can be fixed? Thanks for your vidoes

[@LMAutoRepairs]

Not sure on that system... But you might be able to change only the pump... 👍👍👍

[@emice8984]

Hi to everyone . Maybe someone know , the fuel additive pump is working constantly , when U drive , or just when automaticly regeneration is ON ?

[@LMAutoRepairs]

It only works to pump additive into the fuel when you put fuel in... 👍👍👍

[@pedroneves8288]

Since December 2022 Euroconsumers is elaborating an action against PSA group related to the systematic malfunction, and costly repair, of the Adblue system. But that seems to be the Eolys system. Is it the same thing? Does Mazda 3 have the same system as that Peugeot? Luís, you have showed us previously a Mazda 3 1.6D with a similar problem, right?

[@LMAutoRepairs]

Yes... correct... was the same system... Newer models might be different though... 👍👍👍

[@Fabi....]

PSA is nothing yet... There are more faulty SCR systems in Renault.

[@lubelska17]

How to check the pump itself? I measured resistance -20ohm. After connecting 12v to pump directly it does not start just click

[@LMAutoRepairs]

That is what it does... The pump is not a motor, is a solenoid, every time it clicks, is a cycle, every cycle it pumps a bit of fluid... Hope it makes sense... 👍👍👍

[@igorfedoriv9527]

@@LMAutoRepairs will the pump work if it is not correctly connected to the module, because it does not say where + and where -?

[@MrByootox]

Did u you get a chance to try the pcb you cleaned up? 😁

[@LMAutoRepairs]

As explained in the video... I did, same issue... I could have digged a bit further, but I seen it as a bit of a waste of time when I already knew the owner was bringing a replacement... 👍👍👍

[@MrByootox]

@@LMAutoRepairs Ahh, sorry I missed the bit you tried it and a great follow up episode as well Louis 🤘🤘🤘

[@LMAutoRepairs]

@@MrByootox 👍👍

[@andrewyeo2353]

Another great fix, how does the tank tell car when level is low ?? Is it calculated or is there a sensor in tank? Just asking as unsure on system

[@tschuuuls486]

Pretty sure its calculated, as it's a closed canister. They probably count the pump actuations.

[@andrewyeo2353]

@@tschuuuls486 thank you for the info that would make sense 👍

[@LMAutoRepairs]

Yes... it is calculated... 👍👍👍

[@nunzioforino]

hello.!! i need some help… in a 5008 from 2017, just change the whole tank, brand new, so i can’t reset de fault code… what it could happend.? please help me…

[@LMAutoRepairs]

Have you reset the tank values etc? 👍👍👍

[@anthonyhills2024]

Where is the dedicated ECU for the pump located on the car? I have a 407 that has a new bag but still gives P1446 during power up , precession and OIL ok. Can't get the FAP warning to extinguish.

[@LMAutoRepairs]

Hi Have you reset/programmed the new bag? 👍👍👍

[@anthonyhills2024]

@@LMAutoRepairs My mechanic says the ECU( engine) won't let him return counters to zero. Warning still appears only on initiation and is off when driving. The old bag was exhausted when changed. He thinks pump may be damaged from running dry. Pump is not operating. Where's the dedicated ECU for the pump?

[@LMAutoRepairs]

Depends on the setup... Some cars the system is controlled by the engine ecu itself... Needs to check, and reset the bag, otherwise the warning will remain...

[@anthonyhills2024]

@@LMAutoRepairs OK wildo.

[@anthonyhills2024]

@@LMAutoRepairs Can you trigger a regeneration just by directly manually putting additive in your diesel or does the ECU also need to adjust injection post exhaust valve opening? The reason I ask is I may have to wait for delivery of a new additive pump, and I don't want the DPF to block whilst I wait.

[@lubelska17]

I have errors p1434 and p1435. I teplaced the tank and pump but errors persist. What can be the other reason?

[@LMAutoRepairs]

The p1434, I believe it clears on its own when the system is fully operational and you drive the car for a bit with enough fuel... The P1435, check wiring, connections and signals etc... 👍👍👍

[@nunzioforino]

hello.. same problem here… have you fix it.?

[@Vader74]

how much cost used dpf tank?

[@LMAutoRepairs]

I didn't buy it... Not sure how much the owner paid for it... But I am pretty sure that was an eBay part... You can always check in there... 👍👍👍

[@Vader74]

@@LMAutoRepairs how much is 1 ltr of fluid?

[@LMAutoRepairs]

@@Vader74 Just over £10 if u recall correctly...

[@schaap418]

Hey, can you help me ? I filled the dpf tank and reset it and after 40.000 km it’s empty again how is this possible

[@LMAutoRepairs]

Check for leaks, check that the pump is not "over pumping" is that makes sense... 👍👍👍

[@schaap418]

@@LMAutoRepairs how can I check that? If I use diagbox to reset fluid level it take 10 minutes to let the pump stop

[@LMAutoRepairs]

@schaap418 The reset should not activate the pump... at least not for that long...

[@schaap418]

@@LMAutoRepairs that is when I use the option replace tank or pump it let the pump running to put the air out and there is a notice that I can take max 10 minutes

[@LMAutoRepairs]

@schaap418 Yes... but when you just refill, you shouldn't run that option... unless you have let the tank to ran dry... The option should be just to reset the level or quantity... That's all...

[@benoitbourdaire4194]

Please, how can you take my espace 3.5? Please....I will bring the car, pay, use genuine parts if you want...please

[@LMAutoRepairs]

Too busy at the moment... 🤪 👍👍👍

[@benoitbourdaire4194]

@@LMAutoRepairs I will wait. All I want is a date. Even if it's autumn or winter! Thanks!

[@dorofteiionutz3952]

That tank costs like 1400 $. not 400 $.

[@LMAutoRepairs]

Maybe in dollars and where you live... Not here, and not at the time of filming... Thank you.

[@dorofteiionutz3952]

I will give you a quote in romania .@@LMAutoRepairs

[@Robertnicwlae]

Hello, my pump is broken now and needs replacement, my car is 3008 2.0 hybrid 2012, it S a special tank or is the same on every model?

[@LMAutoRepairs]

They can differ... Get yours out, and check it, making sure you get the same model... 👍👍👍

[@Robertnicwlae]

@@LMAutoRepairs thanks👍👍👍

[@mazi16v]

Fuel light still on? lol

[@LMAutoRepairs]

😅 👍👍👍

[@gillianhartwell1993]

Ooooooooooo9oooooô

[@amarabdelli487]

Thanks for sharing

[@LMAutoRepairs]

☺️ Thank you for watching! 👍👍👍