Peugeot Partner Blower Motor Not Working - Problem Solved

[@alanchan7731]

I had no blower in my van for a year and gave up fixing it after I couldn't sort it. After watching this video, I replaced the relay and hey ho it works. What a God send.

[@wakou222]

Excellent stuff! Clear, not patronising to the layman, but explains the steps! Great work!

[@GerardBurkeBurkesGarage]

Thanks for the kind words 🙏🙏

[@timjarvis5798]

Great video, sorted my heater out in 20 minutes with a 6 quid part. Many thanks.

[@John-m1o3d]

Excellent. Thankyou for this video. Saved me a trip to the garage. My relay was burnt out also. Bought the replacement part from Halfords £5.70 and was told this was correct p.no HEF557.

[@GerardBurkeBurkesGarage]

Happy I was able to help out

[@jamieupandown786]

Did your original part have 35/15amp as the halfords version is 30/15amp thanks

[@jamieupandown786]

My vehicle has aircon.. If that helps

[@almagill]

Smashing clear video, straightforward instructions. Looks like I'm chasing a dodgy relay tomorrow then :)

[@jamieupandown786]

Bought a relay from breakers this morning fans now working.. The owner of the breakers said relays can pop. Usually the cause is either the fan in the way out or possibly a burn in the loom somewhere.... Great video... Mucho Mucho grasias. I'll buy you a drink now 🍺

[@danielzebrowski250]

if the 40a fuse is good and the relay is working properly where to look next?

[@harrisjohann]

Thanks for pointing out this relay man, my relay's coil wasn't fused, it was just carbonized at the contacts. Popped the relay open using 2 flat screwdrivers, remove the spring carefully, borrowed my wife's emery board and rub off the carbon on both contacts, test again and it worked! 💪🏼💪🏼😁 disclaimer : do this at your own risk, I'm a trained engineer and we do this sometimes when in desparate need of urgent parts.

[@mickybro2363]

I just did the same thanks to your advice....and git it working. Thankyou

[@marktyrrell5588]

Just wondering what to do after changed the resistor and relay and getting no power at the fuse in engine bay and fuse is good. Somebody was at the relay plug before and all wires going to it were joined. 2 wires looked burnt at the joiners so I cut the wires and rejoined them and still nothing really lost at the minute with what to do next any info will help thank you.

[@ianowens1577]

top man Gerard, very helpful and easy to follow, many thanks my man!

[@GerardBurkeBurkesGarage]

Cheers Ian

[@theokool1736]

Excellent thanks, my relay had two burnt contacts so didn't even bother testing it and bought new 😊👍

[@Elwooddudes]

Thanks for taking time to make the video. My heater stopped working, all but the number 4 fan setting works. Shall be checking relay this evening! Hopefully it’s something more simple like this this! Thanks Luke

[@eddien09]

Mine is the exact same, all but number 4. Did you fix yours and what was the issue?

[@Elwooddudes]

Eddie Nolan Hi Eddy, it turned out to be the Resistor. The old one was so rusty and shot when I pulled it out! Replaced it with a new one from eBay and it blows on all numbers now. How this helps 👍🏼 Only thing is now I can’t get much heat still through... especially in the footwell. Least it works half the time 😅

[@tsb3093]

Note that if you have the fan working on maximum speed the problem is always the resistor…if the fan isn’t working at all it will most likely be the resistor or possibly the fan motor or fuse.

[@ambiencelectronica]

Hi. Is the horn relay in the same location as this one you replaced? My horn stopped working and stopping the MOT and trying to fix it to book a retest. Thank you for any advice.

[@beachman007]

Nice video But l have a different problem in my perguet partner diesel 2005 1.9 the blower keeps coming on as soon as I start the engine and can't control it what can I do to sort it out please?

[@Bertrum123]

Great video the Irish always seem to make it so uncomplicated thanks

[@londonboy8547]

You just saved me a fortune, thanks for that..brilliant video..

[@GerardBurkeBurkesGarage]

That's great to hear, thanks for sharing :)

[@robertashmole3917]

your video led me straight to it. same fault as yours , burnt spade on the relay.

[@davebradley2660]

hi guys the heater resistor is on the drivers side right above the acc pedal hope this helps guys. this should give you 1-2-3-4 speed on your heater ...not just on full

[@GerardBurkeBurkesGarage]

I just replied to someone about that exact question. Comment sections can be grear, cheers for posting that up Dave I hope Budd Hudd read it :)

[@rachelbellamu3850]

I have a similar problem on my partner tepee but it’s intermittent. Mostly there is nothing when you turn on the blowers but occasionally they will work and 1/2 will be fine, 3 a little noisy, 4 very loud whirring noise. When it does work, 4 will only go for 30second max then you’ll get nothing again. Any ideas please

[@darranirwin1810]

Hi thanks for your upload, I tested my relay and it seems to be working. I was wondering is the next step to test the blower motor? And where would the motor be I couldn't find it behind the glove box thanks

[@bekindalways4387]

This is my issue... Did you sort it after??

[@tjhomeimprovements2570]

Do you know where the heater resistor is on a Peugeot 508 2012?

[@oakfront]

Hello all, I have the exact same problem and i replaced the resistor and respliced the connector block, all before seeing this post. In my haste to fix it I made the error of not testing the feed beforehand as I assumed it would be the block connector but since I have found there is no power to the connector plug in question. I assume this wire goes back to the engine bay. Does anyone have any ideas as to where I go from here as I don't know too much about car electrics and now I'm totally stumped? Any help would be greatly appreciated. Many thanks.

[@warboots35]

Excellent video, I have exactly the same problem just started with my 2012 Citroen Dispatch. Do you know where the blower relay is for that please? I've been looking last few days but been unable to find it.

[@johnjacob6570]

I have same problem did you find it ?

[@Dannoducati]

how did u remove the relay? is it just brute force or is the pins to press in, i can't get it out.

[@GerardBurkeBurkesGarage]

They can be very tight and difficult, pliers can help while wiggling left and right, up and down. Good luck :)

[@simonosullivan1660]

Good Demo Gerard on how to test control current and main current on relays👍

[@GerardBurkeBurkesGarage]

Cheers Simon

[@keithdutton8674]

I have a 2009 berlingo but I can't find this relay where you have suggested to be

[@bekindalways4387]

Under fusebox passenger footwell

[@frapphat]

The fan on my 2011 Berlingo Multispace is erratic. Sometimes comes on, sometimes not. Can be noisy and speeds seem to vary. I'm guessing it's likely to be the blower unit but would appreciate any input. Thanks

[@andrewbrennan3497]

Same problem did you get to the bottom of the problem?

[@mateuszmakos]

Thanks a lot mate, you helped me a lot :)

[@malcolmyoung7866]

Just in time for winter...or a typical summer on the Emerald Isle...

[@GerardBurkeBurkesGarage]

Yep pretty much all year round Malcolm :)

[@middletonbruce4232]

Have you a video of heater resister replace on this car

[@jamieupandown786]

Hi I saw in the comments that the halfords relay part number HEF557 is a replacement. My question is the manufacturer relay is 35/15amp 12v Whereas the halfords one is 30/15amp 12v Will this be an issue. My relay is also burnt

[@jamieupandown786]

Forgot to mention my vehicle has aircon 🤷‍♂️

[@chrismartin5772]

Great video and information

[@GerardBurkeBurkesGarage]

Thank you!

[@s.n.ms.m1846]

Hi my peugeot partner 2010year my driver said under the Steering wheel hetar not working it is cold yir coming under the steering wheel can you help me plz

[@karljennings8813]

Did you ever find the relay ? I also have a 2010 and cant find it on either side.

[@stansalwa2643]

Your video helps me a lot and save valuable time. Thanks

[@GerardBurkeBurkesGarage]

your welcome Stan

[@jimmydean2000]

Fantastic video had exact same problem. Could be a common fault. 09 berlingo 300km

[@jobbiejew]

I still can’t find this relay. It’s a 2012 B9 Multispace I’ve got with this exact issue.

[@harrisjohann]

it's behind the fuse board, mines a 2012 B9 as well. You'll have to lie down on the front passenger floorboard and look up, there are 4 think gauge wires going to this relay

[@nuyess]

Thx for this tip, couldn’t find it without this one! ✅

[@anthonycannon7118]

@@harrisjohannthanks for this additional info couldn’t find it otherwise

[@dpaterson42]

Thanks for an awesome video and commentary.. only wish I had watched this before I pulled my van apart!!!

[@GerardBurkeBurkesGarage]

Thanks very much Darren.

[@johnpaulmongan9709]

Have 5008, heating is fine untill i put it on higher setting, then it will stop working, what dose it mean

[@dpaterson42]

Johnpaul Mongan does the fan restart if you go back to a lower speed? Does a fuse blow? If the fan restarts at a lower speed maybe the fan control is bad..?

[@johnpaulmongan9709]

It restarts at a low speed alright, no issue with any fuse, can you explane more abouth the fan controler please

[@dpaterson42]

Johnpaul Mongan I don’t know much more I can tell you... try a mechanic in Person

[@Bambinohead1]

Excellent, excellent content that could be used to check any relay. Very helpful as always. Good man 👍👏

[@martinamckinlay1633]

All well and good, but how long for? If you have a burn out on the 87 pin (the LOAD pin) then there will be a problem with the motor.

[@GerardBurkeBurkesGarage]

Time will tell Richard, customer is very happy since and I spoke to him last week, it was a low cost repair and will most likely last a very long time. I understand what you are saying but neither of us know the answer to that. I have seen relays in similar conditions replaced and never had another issue. Thanks for the comment

[@sijess01]

Thank you, top man!

[@buddhudd1054]

Well lad. Does that van have a resistor box ? Mine only works on full speed 😒

[@GerardBurkeBurkesGarage]

Yes it does, if only working on full speed resistor most likely needs replacing

[@Djjsbishjebjjejsjdin]

Excellent videos,keep it up 👍

[@GerardBurkeBurkesGarage]

Thanks Paddy

[@MstfGold]

Thanks dude it's working I like this ❤️

[@GerardBurkeBurkesGarage]

Glad to hear that Mustafa

[@cancuniavids8121]

Great Video, thanks for posting it. What software were you using to show the fuse layouts?

[@jobbiejew]

It looks like AutoData

[@kan815k]

Every manufacturer should make relay holder bright colour instead of black. So that we can see the burnt marks on the holder.

[@justindomagalski9015]

Had similar problem,only setting 4 worked on mine.checked fuse its fine, got new relay from Halfords and still the same.any help much appreciated too cold for this hahah

[@GerardBurkeBurkesGarage]

Blower motor resistor is the likely fault

[@justindomagalski9015]

@@GerardBurkeBurkesGarage where can I locate this as I cant see it under glove box???

[@Pedrosanchezzz]

Justin domagalski did you find it mate? Same problem for me

[@markh5648]

Anyone found it? Same problem as me

[@davebradley2660]

hi anyone know where the heater control resistor is situated (not the relay )

[@anthonycannon7118]

Usually just above the accelerator pedal held in bulkhead by one 8mm screw hard to spot just follow the wires by blower

[@surinwichchuwong8278]

Thank you for helpful.

[@michelducatel5398]

Hi ty 😊

[@JohnnysSpeedShop]

Nice work Gerard, gotta love relay testing...did it have any moisture in it ? Or just burnt out.

[@GerardBurkeBurkesGarage]

No moisture to be seen Johnny, just had enough I think :)

[@taunuslunatic404]

I rented one like that for a 2,000 km trip a month ago. Even though it was almost brand new, the driver's window switch seemed to be about to fail. Have you had this problem?

[@GerardBurkeBurkesGarage]

Yes replaced a window switch just last week, not a difficult task just surrounding panels need to be removed.

[@derka6741]

Great

[@MunawarVeer-pq7wi]

Ac peguet partner not work

[@steliosxarkianakis1939]

X

[@gills.manjit6306]

I have the same problem with my Citroen xsara. Where about would the Xsara have such a relay? Damn I've opened up my whole blower motor unit, changed the transistors on the actuator unit next to the blower motor unit. Problem seemed similar to this chap on the link attached, kzbin.info/www/bejne/bomYimBsa8iMiaM ..... :) even ordered a part from uk of e-bay (live in Finland) part not suitable..... hahahhaha and snows are already falling in the north- GOT= WINTER IS COMING...... SO ANY ADVICE GERARD I am dying...... the vehicle is supposed to go for it's inspection ( extremely strict here) and everything else is okay

[@danielradasanu928]

can some one help, i check the fuse and i remplace the relay( Was fine the original but just in case) and still no working and more things to check?