PID Control in a Micro800 PLC programmed in Connected Components Workbench

[@ceiecentroeducativo8439]

How do you write the Kc, I and D gains? THey are not in "write mode" in the PID_GAINS variable. Thanks

[@glauciojackson2269]

Great Job, Aaron! can you share that files to study?

[@fredriklarsson997]

Hey ! You make really good and educational videos. I have a suggestion for a next video. Suppose we use 2 hydraulic cylinders. Measure the position of each cylinder with an analog instrument. The cylinders are controlled by each one propotional valve. How can we program so that we have acceleration and deacceleration? How do you program to get a master cylinder and a slave? The idea is that these cylinders should run synchronously. / F

[@aussiegruber86]

What are your thoughts on the micro800? I have been using the automation direct gear for some time and can't fault it but looking at giving this a try

[@Anthony-sg7xk]

Hi, bro, I watched your video many times, but one question, could i try the PID without Micro800 controller but just CCW?

[@joseangelvegamejia1220]

an apology you will not have the programming