Great tip about moving the point where the split of the curve will commence! And of course the fillet at the end makes everything looks so "finished" and polished. Thank you very much. It is always so satisfying to see such nice surfaces created with Rhino :)
@PJChenJewelryDesign6 ай бұрын
Happy to know you enjoy the video!
@모리-k4rАй бұрын
great! thanks for various tips. Your videos are also helpful for those learning advanced courses.
@PJChenJewelryDesignАй бұрын
Glad to hear that!
@MasoumehGheblei-ek9uo6 ай бұрын
Thank you PJ...It's very helpful 😊
@PJChenJewelryDesign6 ай бұрын
Glad it was helpful!
@humbertocastillo94396 ай бұрын
Excellent thanks PJ
@PJChenJewelryDesign6 ай бұрын
Very welcome
@alainbrochet56105 ай бұрын
Toujours rationnel et compréhensible !
@PJChenJewelryDesign5 ай бұрын
great. thank you
@miriamm50766 ай бұрын
Thank you! This video helped me a lot.
@PJChenJewelryDesign6 ай бұрын
Glad it helped! thank you for your support!
@martinpontbriand80486 ай бұрын
Thanks PJ
@PJChenJewelryDesign6 ай бұрын
no problem!
@RonAdamsky6 ай бұрын
Before Sweep2Rail and after Dupedge I had to do join curves to correct sweep.
@rirarari18873 ай бұрын
Hey PJ, if I want to make this ready for printing but I want the stone to be set, do i need to add extra material for the setter?
@PJChenJewelryDesign3 ай бұрын
If you plan to have bezel set, Yes. If you plan to have inlay, No
@rirarari18872 ай бұрын
@@PJChenJewelryDesign so let's say i offset an edge around where the stone will sit and extrude that for 0.25/0.5mm high. would that be enough?