pl62x water level sensor

[@chadgregory9037]

0:19 getting a good look at that opv water reroute =]

[@Songs-jx9rw]

My issue in Bianca was that the wire sensor underneath the water tank was lose and not connected properly. Pushed inside and i got my signal back!

[@ZiefM]

The problem with this system is that, as we don't see the water level (I have a PL91T) when the sensor detects the magnet, the machine shuts off 99% when we're making a coffee. A warning led at 1/4 of the tank or a window would be very usefull.

[@lelitinsider2977]

in the pl91 if you run out of water during extraction, this continues for 15 seconds, after these 15 seconds the pump stops

[@ZiefM]

@@lelitinsider2977 Maybe the firmware has been updated since, but mine shuts off right away, without warning. (Bought in 10/2020)