PLC to DRIVE Communication (TIA PORTAL V-13)plc

communication of drive to the PLC

[@razirahnama4197]

Thanks very much. Goss bless u . Best Training , clear , slowly and instructive.

[@user-gt4qc9yr4w]

Useful lecture sir thank you very much

[@AlfDot]

Most welcome

[@mohammadomar1558]

nice tutorial

[@tarnumlordemmanuel8200]

Can we control the speed using him instead of potentiometer?

[@jobsinpakandgulf621]

nice to see can you tell me input 16 register hex no whr mention? undrestood output

[@rezamagham4495]

Good

[@shridharnaidu6657]

6RA80 ON PROFIBUS communicate ok but when start to download backup project shows error on BOP 33 & A01420. Pls help us.

[@nelsonpantaleon7751]

About network 4 drive speed did you scale analog input for 0 to 10 volt signal for iw 64

[@AlfDot]

In this video no we haven't if you need any help how to do scaling contact me through mail

[@nelsonpantaleon7751]

@@AlfDot whats your email

[@nelsonpantaleon7751]

Its means just connect the potentiometer to the analog input 0-10 volts then select and thats it im right no need to scale so theres no limit the over/under shoot

[@AlfDot]

[e-mail]

[@tarnumlordemmanuel8200]

This hexa code are they same on all drive like eg altivar, g120

[@AlfDot]

Same for siemens

[@tarnumlordemmanuel8200]

@@AlfDot sorry I mean I can use the hexa code to control altivar? Please can you also make videos on how to control altivar in tia portal using standard telegram, thank you

[@huntersblue]

Why not use sina speed block?

[@AlfDot]

In video we are showing in traditional way

[@saadfuns]

bro where i find the proper telegram with control word adress details

[@AlfDot]

images.app.goo.gl/7TbCQup3BgR3BpAj6

[@abhishekgiri6907]

For the commissioning of drive first we use the starter of simotion software for allocate the PZD ...you only shared the half and incompleted information due to this many people will be distrub

[@AlfDot]

Here in this video we are giving how to communicate plc with drive and run the motor...pls check title if you want we will help you to do parameterisation by using manual...but you need "starter"or "IOP" or atleast BOP

[@AlfDot]

Plz check this video kzbin.info/www/bejne/pKDEmpieosijmtk

[@surajharekar7928]

How to start stop drive through profinet

[@AlfDot]

images.app.goo.gl/pke5RfRmX9YfURNG7

[@AlfDot]

Plz check with hexa decimal codes

[@surajharekar7928]

Need help

[@AlfDot]

Contact me through the email

[@saadfuns]

send me your email id

[@abhishekgiri6907]

Without drive starter software how can you run the motor

[@AlfDot]

Can you elaborate the question

[@abhishekgiri6907]

Without optimization how are you running the motor And without drive software how will possible the optimization

[@abhishekgiri6907]

If don't mind May i know your experience bandwidth?

[@AlfDot]

7 years

[@AlfDot]

Have you tried with basic parameterisation