POD GO Finally Gets an Update - NEW CABS, NEW AMPS, NEW FX!

[@WarrenPostma]

Since buying the Pod go at v1.0 firmware, they've consistently added new features, new effects, and improvements, v1.1, 1.2, 1.3, 1.4, and now 2.0. Very pleased to be a Line6 customer.

[@thomasdiscipio]

My favorite intro of yours thus far. Stellar! Earlier this year, I shopped the Valeton GP-200 against the PodGo and ended up with the Valeton. But this latest update for the POD Go is making me rethink it... It'd be super interesting to get your take on the Valeton GP-200 at some point as well.

[@keithveloso2822]

Same here. I am torn between Pod Go and GP-200. The captain @ Anderton's have reviewed the GP-200 extensively. It would be great to hear Mr. Cordy's take on the GP-200.

[@joemiller9856]

Line 6 is definitely a leader in ongoing support

[@santiagobarrera2446]

Only stinks the fade in between 1 bank of low gain and 1 of high gain. Like rythm to lead pull down all the volume and then changes cuts off all the power of the song

[@kurtz1993]

YES!!! I was hoping these cabs were introduced into POD Go! For me, I am pretty much happy having only 1 cab as my signal chain is always pretty bare bones. Thank you for being the right source for Line 6 related stuff, not only because I knew about this update because of you but also because you always go in-depth and have great demos.

[@HenryAmat]

John, thank you so much for reviewing the new and long awaited 2.0 update so quickly. That intro is fantastic, you are a great inspiration. I hope you will add new presets with this update to the Pod Go folder. Thanks again. Cheers

[@steved1099]

Dont usually get excited about updates, but this one has made the pod go shine. Love the cabs and new grammatico. Been looking at getting a GX100 but this free update may have just saved me £500

[@ChadwickRider]

Your demo tracks are always so good John... truly talented, it's obvious you've put a lot of heart and work into the guitar.

[@nedludd3641]

It's not just what you can do with it, it's what you can bolt on after 🌟

[@CausingLewis]

That intro song! ❣

[@wavewithus4081]

That fake-out ending got me good. Happy it went on for longer!

[@ac8704]

I see these come up for sale used around $300, and I'm tempted to get one as a backup rig

[@ejRecording]

Not bad, I've been looking at the Valeton gp200 is 265 on eBay new but tempted to go line 6 used

[@LivinginLosAngeles-re5yx]

​@@ejRecordingI had the GP-200, resold pretty quickly. Tones aren't there (sound very synthetic) and drum machine was terrible. Great form factor and well built but tones not anywhere close to A-Tier, and I have a HR Prime and Kemper Stage. Could have been great, but the tones are odd and synthetic to me.

[@ScottMacLeodCompany]

Thanks for the review. You sound great on the PG. Can't wait to hear mine upgraded!

[@iankenny1089]

Wow John,…Total Flow…you were in there…I could see you were enjoying it too ,…Fab stuff mate !…and I’ve only watched the intro..just wicked playing…I’ll watch the rest of the video now…

[@ruvchbrevth]

Fantastic as always, sorry about the end 🙃

[@Arthur_My_Dear]

Sometimes you play like you’re really, really enjoying yourself. This one one off those times. Monster playing in the intro

[@MarcCoteMusic]

That intro jam was some of the tastiest, most melodic playing I have heard in a very long time.

[@bestboy897]

Delicious opening jam

[@wiguitar7633]

John I am a big fan and I am learning a lot of ypur phrasing which I truly find inspiring. What is your go to reverb/ delay types for the lead sound?

[@Diego-ke6bq]

John, where can i download that EricLead preset¿ sounds so cool

[@robertkingi5087]

Intro - Fancy stuff alright! LOVE THIS!!!

[@JohnSpo]

I did the hack to my PodGo to free up the extra non-amp blocks, so I'm not going to update this until I can confirm that the update won't prevent me from using those presets.

[@HenryAmat]

Hi. I just updated and can confirm that the hack to liberate blocks still works with Pod Go 2.0, so no problem with your hacked presets.

[@JohnSpo]

@@HenryAmat okay great news. Thanks for letting me know

[@tomfoolery4077]

@@HenryAmat hack you say? How does one do this? Because the FX Loop Block is a waste for me

[@sunburstshredder]

Great news for me since I just bought a Pod Go!

[@anurupguhathakurta2913]

Good to find someone from the other side of the globe who shares my love for TOOTIMETOOTIMETOOTIME and PodGO and Blue Strats

[@kelvinpell4571]

I am having problems with this update. I downloaded the install files and backed up, installed 2.0 but had to reinstall all of the IR's for acoustic pre-sets when I reloaded them Later whilst rehearsing the display kept changing between modes with the effects buttons flashing in and out of the display. Very disconcerting if this had been happening at a gig. I will reset and revert to the earlier version if this continues

[@dumpstertrash420]

I use the amp out to go to a little mxr 48 magnum power amp into a cab and then the main out goes to the PA and monitors.

[@LaurenceRutherford]

John... any chance you could check a newer non-wireless Pod Go to see if the impedance issue is fixed on newer units? I was considering a Pod GO, but the impedance issue does put me off. How big an issue is it?

[@ronakman9725]

Hey do you have the input impedance issue, or did you buy it recently where they apparently fixed it.

[@josephimmanuel5280]

Plz share your pod go global Eq settings... Your tone work n ply is very nice.. But not able to get the same patch bcz of my global eq ..

[@HansRahbekMusic]

just following along

[@bryantwalley]

Just some advice I have found helpful over the years with these type devices. Set your global eq straight up (neither cut nor boost) while you are setting up your patches so that they sound like you want them to. then when you have to go somewhere else, you can dial in the global eq and not have to change the settings on the individual patches. yes, there will always be a few exceptions but you will figure it out after just a few times so long as your individual patches are consistent. I have done this with the Helix and Boss units and not had any issues dialing in a room quickly when needed.

[@slicksalmon6948]

It needs a Bluetooth input so you can practice with backing tracks without hard wiring. What is the “impedance thing”?

[@DavidEidelberg]

Interestingly I have not received notification from L6 that the release is official. I am a beta tester though and have been testing it.

[@boimesa8190]

how do u become a beta tester?

[@DavidEidelberg]

@@boimesa8190They ask you. Out you can reach out and ask.

[@StephenWLong]

Would be perfect -if only I had known I would want midi send

[@clives555]

Awesome!

[@cezarsantana]

Killer intro JNC!!!

[@SirTupsAlot]

Any chance you'll update your Pod Go presets package for v2.0?

[@BobJones-bh9qz]

I’m still hoping for them to add a favorites feature, it’s so simple but would save so much time

[@worthmoremusic]

I tend to think Helix, will take better care of the Line 6 products..as they have been re: Yamaha since Helix owns them. I think for the money, Line 6 Pod Go is a great, affordable multi-effects unit....so is the Ampero Stage.

[@bryanguzman1113]

Are you only using the Pod Go?

[@philfyphil]

I wish the Pod Go had a direct bypass out, so a separate un-processed signal could be recorded.

[@steved1099]

At 2 mins mark - kzbin.info/www/bejne/nqqqdYqDhLCYbrsfeature=shared

[@steved1099]

kzbin.info/www/bejne/q5i1cnhnoqZ4f9kfeature=shared

[@cliverkay]

Is the Elmsley named after Adrian Emsley the amp designer for Orange ??

[@martiboucat]

I think it has to do with something about a magic store, but it might be also a wink to Orange

[@BobbyCulpepper.srv3fender]

Still no nobels

[@evangelannobilbrew7090]

Will you get update problems if you've jailbreaked patches?

[@GS-uy4xo]

Another post mentioned this - looks like we’re ok 👍🏼

[@evangelannobilbrew7090]

So those with jailbreak patches can update without problems?

[@GS-uy4xo]

Yes - A little further down on the list someone confirmed it. (Johnspo)@@evangelannobilbrew7090

[@ranprdn8592]

Share this preset plis

[@Brandonfuwo512]

Im kinda disappointed they took so long and didn't added the dual block ir or less dsp consumption from the IRs. Guess I'm changing to the Stomp then 🤷🏻‍♂

[@RevuitNet]

I think you expected a lot from the Go… seems you were waiting for helix specific cross over which was never going to happen due to the differences between the lines. Sounds like you should have always gone with the hx

[@Deep_Jimpact]

Ngl, this very much feels like a second video. You know when it’s got that vibe?

[@middaywasted3653]

wat