This video shows the installation of the XL Fender flares on the Intruder (2019 Ride command Edition)
Пікірлер: 8
@vengeance2683 жыл бұрын
Can you tell me more about the rack you have on the back and where you got the radiator guards?
@westtexastarantulaoutdoors37513 жыл бұрын
Hello Ray, the radiator guards were purchased off of amazon. Here is a video that expains exactly how the rear rack was made kzbin.info/www/bejne/gITWkKqDrsyoqrc
@lennypoage58022 жыл бұрын
where did you get the door storage? i can’t find anything for a general?
@westtexastarantulaoutdoors37512 жыл бұрын
I couldn't find any either so I thought outside the box. Here is a video that I did on them kzbin.info/www/bejne/mJbViol3bremaKM
@stacinash2526 Жыл бұрын
We have the same fender flares. My question is how do you get the front ones to stay on?? you have no way of putting your hand in behind to push the plugs in connecting them snug against the machine. ..... or did you just not worry about that and just screw the fenders into the side of the machine? I hope that makes sense.
@westtexastarantulaoutdoors3751 Жыл бұрын
We used the stock snap/push in connectors that were being used on the stock flares. And the push pins that also snap in. I do remember a few of them were tough to get snapped in. I don't remember how we got them handled, but they eventually snapped in.
@trevormichaud4639 Жыл бұрын
For anyone else watching, you'll make it alot easier on yourself to also take doors off so you can remove the inner fender. This way you can put required pressure for the original pressure clips to take hold. Believe me it will save alot of time and swearing. The backend was easy.
@keving574 Жыл бұрын
I'm sorry, but this really is not an installation video. A total lack of detail (i.e., did not show specific push pins and screws to remove, nor information as to where exactly to drill and Install new screws/push pins. Waste of time.