www.hunterworks.com Just general info about what a misfire code really is
Пікірлер: 50
@kellydavis49542 жыл бұрын
thanks for clearing that up ,never understood why some videos say the belt causes a misfire
@badboyoak2 жыл бұрын
After I went to the duraclutch I have been chasing the misfire fault. So brand new clutch primary and secondary. It normally will clear After a bit. Also put new plugs in so any help would be appreciated.
@Hunterworks2 жыл бұрын
They offer a free flash for that if it started within 100 miles of the install
@ethanh95352 жыл бұрын
What would cause my 2017 Polaris RZR 1000 S to backfire/like a popping noise when I start slowing down only. Any help would be appreciated. Thanks.
@Hunterworks2 жыл бұрын
An exhaust leak can or if you have a tune on it and you are not letting off the gas pedal all the way
@ATV_HowTo Жыл бұрын
Got the two misfire codes, belt was definitely worn. Clutches bad too. Replaced primary, secondary, and got new belt. Codes still present. Any ideas?
@Hunterworks Жыл бұрын
Not enough information email me todd@hunterworks.com tell me the vehicle what exact brand clutches what collect kids etc. and I can help
@anthony46021 Жыл бұрын
I installed dalton clutch kit on my 2015 xp4 1000 and set it up for my 32" tires. Ran 28" 9 paddles in the dunes and threw misfire codes and went into limp mode. Are the smaller tires my culprit?
@Hunterworks Жыл бұрын
potentially, put your 32 back on it and run it hard and see, you might have gotten you a new clutch issue you didn't know about
@angelromero52492 жыл бұрын
what can a 2017 rzr have when I'm accelerating and I let off the throttle it makes a weird noise and stops moving then it's hard to change between the different gears PRNLH
@Hunterworks2 жыл бұрын
I would start with our how to troubleshoot a primary clutch video
@jeffmasengill1295 Жыл бұрын
2018 ranger 1000xp. I get the misfire code at start up while engine is cold and machine not moving. If engine hot and I start it I don't get the code. After driving it couple minutes it clears code.
@Hunterworks Жыл бұрын
Can’t say but that’s not clutch.
@heiditye756611 ай бұрын
2019 Polaris rzr 1000 eps s4 code 65590 7. Any idea? Doesn’t seem to be giving us any issues but engine light is on with that code
@Hunterworks11 ай бұрын
Without looking that actual code up, no pretyy sure is a misfire code though, have you floored it and ran it to top speed yet?
@defensivemode64214 ай бұрын
Hey I bought a 2021 Polaris rzr 1000 xp high lifter drove it one time it ran fine, 2nd drive I hit a hole and it went under and after getting it unstuck it’s throwing same codes here. I’ve replace spark plugs new belt. Afterwards I got to 65 miles an hour and then I turned around drove back and rpm hit 8k and then dropped to 7k back to 8k and then dropped again and code misfired. I had the gas pedal all the way down when this happen? Any ideas?
@Hunterworks4 ай бұрын
You need to get into the clutch and see what kind of damage you see of just full of mud and water
@damourssteeven Жыл бұрын
2023 9r 3miles in to the ride. Got a DET and flashing chek engine. Changed plugs nothing. Would like to know more on what is the general purpose of the DET system. 91oct pump gas
@Hunterworks Жыл бұрын
what is a 9R? Take it back to the dealer since so new, we have not dealt with the DET system on it
@damourssteeven Жыл бұрын
@@Hunterworks its the new polaris rmk 900r 2023.
@Hunterworks Жыл бұрын
@@damourssteeven not sure utv have it. The trick is finding out why it’s denominating. But I’d have it back at dealer. Ecu might have too much timing in it
@damourssteeven Жыл бұрын
@@Hunterworks i added octane booster in it and it is less intense i only get the DET code while going full throtle. im bringing it to the dealer tomorow asap
@muraliramadoss9577 Жыл бұрын
Hi sir Polaris 1000cc xp turbo 2017 modal.strtiing good but moving very slow and heavy miss fireing.plese sir what is tha prablam sir.
@Hunterworks Жыл бұрын
Not enough info to go off of, email me todd@hunterworks.com
@IronHunteroutdoors9 ай бұрын
What if you ranger is idling rough and when driving it it seems like it wants to back fire or stall out
@Hunterworks9 ай бұрын
Are you getting a code on the dash?
@IronHunteroutdoors9 ай бұрын
@@Hunterworks I just realized that you can check that so I will when I get home
@grantjohnson3110 Жыл бұрын
Any idea what could cause a intermittent code. I come on every time we ride but always clears itself pretty quick
@Hunterworks Жыл бұрын
Sometimes it is hard to find until it stays until cleared manually. I can only tell you what to look for in the clutch to see if that is it. if you hit a rev limiter when you floor it at any speed it is the clutch
@seanheavner358Ай бұрын
How do you reset the codes on a 2012 rzr800s @@Hunterworks
@HunterworksАй бұрын
@@seanheavner358 Sorry, I do not know, I would assume once you fix what is causing the code it goes away, heard undoing the battery for a few min too. Not really my area of expertise.
@davidpic-gu5tc3 ай бұрын
after i went to the duraclutch, now i'am getting the misfire fault 65590. brand new clutch primary and secondary. It normally will clear After a bit.
@Hunterworks3 ай бұрын
No, they offer a free ecu flash for false misfires.
@davidpic-gu5tc3 ай бұрын
hi, how did i get the free eco flash, thanks david
@davidpic-gu5tc3 ай бұрын
HI, how do i get the free eco flash? thanks! david
@davidpic-gu5tc3 ай бұрын
no need to reply, i found the sheet with the information i need to send in the ecm.
@Hunterworks3 ай бұрын
@@davidpic-gu5tc contact where you bought it, should be a form in the box
@mickeysouth65802 ай бұрын
I have a code coming up 1 51 ,what is the meaning of this code
@Hunterworks2 ай бұрын
a google search says this "code 51 is a stuck open injector on cylinder number one. It runs poorly at lower speeds because it can not handle the excess fuel being dumped into the engine"
@joshrobins65772 жыл бұрын
Great video, good information.
@richardshafer8105 Жыл бұрын
I just dropped my Polaris ranger XP 1000 off to the dealer with a misfire code 1st thing he said the belt was hourglass due to belt slippage and I said I don’t think so I think it’s more than that it only has 2600 miles on the belt and they said nope it’s a belt issue and I said They need to checked for something else that is causing damage to the belt. Their reply is there tech has been doing this for 13 years and he knows what he’s doing.
@Hunterworks Жыл бұрын
What year ?
@tomayers6289 Жыл бұрын
Id have to agree belt, we change belts alot more often then 2600 miles.
@Hunterworks Жыл бұрын
@@tomayers6289 you need to contact me.
@Wearedoom Жыл бұрын
@@tomayers6289 I've never had a belt last 500 miles lol I have learned a lot on these videos though and just recently put the HW belt on, so we'll see.
@Wearedoom Жыл бұрын
Kind of like brakes, 500 miles and they are done. Found a lot better luck with brass though.
@testerdennis67 Жыл бұрын
2023 RZR Pro XP only 4 miles on it yes 4. I just started the machine up and 2 misfire codes 65590 & 65592.
@Hunterworks Жыл бұрын
better take that one back to dealer, might be the bad clutching set up and wrong washer in primary but so new, I would take it back
@testerdennis67 Жыл бұрын
@@Hunterworks thanks for your opinion, I will be calling the dealer tomorrow.