POLARIS SLTX water inlet outlet hose routing

[@butchalvarado1411]

I think you're set up is fine. I think it's just two different setups to supply water yours has two lines one to supply the manifold one to supply your main supply. On the other set up with the t you have one main supply and teed off to supply the other basically two different ways to skin a cat I think they have different setup for different hauls. I have an SLX but I have those fittings on your exhaust but nothing is on them it's just set up differently

[@skylaradkins8409]

Hey man i have an 96 sltx 1050 same as you. Had to replace the impeller ans stator pump over the winter. Im trying to see where these hoses go. There like a purposeful holes under the driveshaft bearing that i never seen. Any help.?

[@jonathanrose1413]

Hi there I just bought a 97 sltx 1050 and my hoses are routed the same way yours are and mine runs just fine

[@rorydennis3344]

Where do I hook garden hose to the blue motor in 1994 sl650

[@Chipper1807]

Same spot

[@Chipper1807]

That gold screw on top of the motor. Un screw and hook a flush kit

[@yrg8596]

I just bought a 1998 Polaris sltx today and got it running in 2 days it wasn’t starting cause of a rusted contact point for a fuse but it runs and it just automatically shuts off when going slow but when I’m going fast it’ll go all day any idea?

[@craigthibodaux]

Getting water coming out the spark plug holes when firing it over. Do u think it could be the o rings on top of piston housing ? Or manifold gasket? Trying to figure out how water getting in

[@Robertksinmi1992]

If it’s coming out circle around the spark plug then you just need new orings

[@mogyver69]

Are you running it on the hose? when your checking?

[@craigthibodaux]

Yes straight out plug holes... while the water flush was hooked up. Tore it down to pistons and didn't find anything. Thinking orings wore out .

[@tonysipe8441]

I'm working on a 99' 1200 Genesis. There was no thermostat in this one. I know for sure it's never been takin apart before. My parents have owned it from New.

[@atypicalhiker]

I picked up a polaris with a no spark condition. It needed a cdi box. Polaris had horrible problems with the Ficht ignition systems. They mismatched the stator to the cdi and it always will take out the cdi box. This was on the Virage models. They were also bad about the flywheel magnets coming loose. I will say my 2002 Virage 700 rides better than the Kawasaki jet skis. It starts better and uses far less fuel because it has a single carb. I will check my hoses but I remember my thermostat hose running all the way out to the rear.

[@mogyver69]

Appreciate the feedback. I've owned several Polaris PWC.over the years and Ive collected many spare parts since there getting harder to find. Ive owned 750 SLT, 780 SLT, 750 SL, SLH 700 and now the SLTX. Never had any issues with the cdi or stators. Had issues with driveshafts, holes in Pistons, index on crank and have replaced pistons and rebuilt at least 3 or 4 Fuji triples. Easy engines to work on. Rebuilt many carbs and flushed gas tanks with bad fuel but with all the info on bad CDI and ignitions I've never seen one personally. I've had a voltage regulator go bad on me. I have spare CDI, coils , wires, cylinder and pistons just in case I need one eventuallly as I have purchased a couple Polaris over the yrs for spare parts machines. I even have extra jet pumps and impellers in case. If you have pics for me text them to 2089811192. Thanks

[@ShadetreeJetski]

It was the Virage models and the G⁸enesis models especially if they had Direct injection systems. The cdi box can cost 1400.00 to replace. I think most of the models you listed were 90's models. I am talking about 2000 and up versions. It led to polaris' decision to quit making jet skis because of the unreliable electronics.

[@ShadetreeJetski]

I am going to my local jet ski junkyard I will see if they have that model you are working on and send you a picture.

[@senypamp392]

Good afternoon, I'm from Russia, I ran into a problem with gasoline not entering the carburetor, all the fuel goes to the return drain, WHERE CAN I FIND THE MANUAL?

[@johnhowell5536]

no T in mine. It is set up just like your SLTX

[@stimpsonjcat67]

"My mama always said red engines were da debil!"

[@jeremyhaas7356]

Update???

[@jeradmoe5899]

9:33

[@jeradmoe5899]

9:33