Polaris Sportsman Radiator Flush and Fill Episode6

[@ChrisBartand8400Feet-fw2sl]

Great five minute video...

[@travelteam89]

Man you're killin me with the plastic pieces.....the center pieces come out

[@ericfraser7543]

You know those plastic grommets 1:00 you ripped out have a center pin, if you pried on that center pin they would come out without destroying them so they could be reused.

[@iaff801]

exactly

[@SpicyMcGeezak]

I was wondering why he was destroying those..

[@PeytonKaufmann]

I just destroy mine and use zip ties they work great

[@indridcold8433]

I had to pee a few times during the video. But very nice video indeed. Excuse me. I have to drain the boa again.

[@Nicholas-cf2dw]

Where does your overflow line go to on the radiator red cap

[@Kevin98765]

Hello my fourwheerler is the same one 500 HO it start but won’t stay running what could it be ?

[@TorrentPerformance]

Kevin i suggest finding a mechanic for this issue if you dont know where to start with the problem.

[@Kevin98765]

Also how much Anti freeze did you put ?

[@PandBMotorsports]

Someone needs help with video editing.

[@morganathfab8727]

@torrentperformance question for you... My 2000 sportsman 500 cooling fan will not kick on, the coolant just gets to the point it boils over. I have tested the coolant temp sensor with a heat gun and it kicks on, and even replaced it. I can jump the sensor’s connector as well and the fan turns on too so I don’t think it’s an electrical problem. The water pump seems to be working because I can see coolant flowing back into the radiator with the cap off and the flow increases with rpm. This started happening after I replaced the coolant. Any ideas?

[@TorrentPerformance]

radiator cap with the spring isnt working properly Im guessing hard to say without it in front of me. Take the cap off and retighten it.

[@morganathfab8727]

@@TorrentPerformance thanks for the reply. It’s actually boiling over out of the reservoir, the cap stays tight. The fan just isn’t kicking on to bring the temp down. The coolant sensor works and the power going to it is fine, it’s almost like the coolant in the sensor side of the radiator isn’t getting hot enough. My radiator’s input and output hoses are on the left side and the sensor is on the right side.

[@lordnikon6786]

@@morganathfab8727 Coolant shooting out of the reservoir cap could be a blown head gasket.

[@morganathfab8727]

@@lordnikon6786 I actually got the fan to start kicking on as it should...coolant temp stays stable now 🤘

[@johne5086]

@@morganathfab8727 so. What did you do to get the fan running again?

[@jodytucker4474]

you raise the front end up to burp it

[@RobJob110]

What exactly is the coolant you use? I just bought a 2010 Sportsman 500ho and it didn't come with an owners manual. So I'm kinda lost...

[@TorrentPerformance]

I run only amsoil products in my powersport stuff as i am a dealer. If you want you can email me directly and i will get you all sorted out on fluids.

[@kingblack22ss]

@@TorrentPerformanceis this clear or green coolant

[@paulkelm6550]

Thanks for sharing, but I could not watch it without feeling sick. Too much camera motion and jerking around.

[@ncbrothad]

So the old one can’t be used ?

[@TorrentPerformance]

The old what can't be used?

[@ncbrothad]

TorrentPerformance washer. I have the exact same bike and I’m having overheating issues. So I’m going to use this video as a guide. But I don’t know what type of washer you are talking about. I guess after taking it off I’ll go to the hardware store

[@TorrentPerformance]

On the water pump? Get a new copper washer it may leak without replacing. Is the fan turning on for the radiator?

[@ncbrothad]

TorrentPerformance no I had to straight wire it

[@TorrentPerformance]

Ok replace that washer when you drain. Overheating is a big issue on that engine. What do you think is causing it. The amsoil coolant boost fluid you add to the coolant on change can lower temps up to 25degrees. I highly recommend it if your gonna do this.

[@stevo5521]

It would have been a better video if you would have explained what you are doing. Thanks for the effort.

[@mrbunker9155]

🎶🎵🎶☠💀

[@jaybourbon8608]

My 05 700 sportsman would not drain from that water pump bolt?

[@TorrentPerformance]

tried to drain it while the engine was hot didnt you? Engine needs to be cold to do this.

[@brianoliver9336]

30 minutes on how to get a push pin out

[@1scottburns]

Oh yeah.... voices wonder. And poor lighting.

[@Al-jv2xb]

Shorten your videos. That was a maximum 10 minute video.

[@TorrentPerformance]

Lol oh ok al

[@teedee5669]

Wrong tools used, wrench skills obviously lacking, faulty procedure followed....glad this guy ain't working on my machines

[@TorrentPerformance]

Lol thank god i don't work on your stuff Tee Dee. Perfectionist like you wouldn't last on a farm.

[@teedee5669]

@@TorrentPerformance Nonsense, working on a farm has nothing to do with maintaining equipment poorly...unless it's the proverbial "funny-farm"