Pontiac Water pump Divider Plates

[@roninthedestroyer8958]

I was thinking about adding a either a brass ring or a stainless steel ring to make a better seal.

[@johnhotrod3231]

Did your final mod on the plates successfully keep your engine cool? Thank you

[@anthonysantiago1999]

My Question is being that the Impeller is already shielded, is this mod still required?

[@detectiveareafour3030]

Yep, it solved the overheating

[@detectiveareafour3030]

@@anthonysantiago1999 yes the mod is NOT fabricated enough

[@roninthedestroyer8958]

Also you lose flow from both ends because they are not sealed. So if you could seal at least one end so all fluid flows in the water port.

[@scottmccarthy3953]

Can you tell me where the gauge came from?