Pool Heater Install and Set Up

Fibropool FH-120
Have a professional electrician make sure the unit is properly wired and grounded.

[@geoffreyshaw2758]

After much research (so many people online complaining their heaters started leaking in 1-2 months!) I thought it would be best to put the heater before the chlorinator due to the corrosive nature of the chlorine, but you are the only one I've come across to specifically point it out and even suggest a check valve. Thank you this was very helpful.

[@sdgelectronics]

You've probably already found out, but you don't want to be running full flow through your heat pump. You'll only get good efficiency with a specific temperature drop between inlet and outlet which will be listed in the specifications, so normally you'd install a bypass kit across the heat pump to divert most of the flow.

[@sfranks88]

solid video with a ton of great info

[@LJsSavoryKitchen]

I'm think about this heat pump. your setup looks good. i would like to know what the water temp is that is getting sucked into he return and what the water temp is on the pipe that is coming back to the Pool. Also, I would recommend you burry the pipes so that no one can trip. Thanks for your video.

[@Red-lu3ku]

Great job!

[@TVJAY]

How much does it cost to run? What kind of temperature increases are you seeing?

[@SpinDocJoe]

I think I have the same heater, a 20000 BTU model. Mine is branded Doel. The instructions for the control panel are terrible. Do you have a source for more detailed info. Were you able to switch yours to F from C?

[@thithamduong2223]

Solar heater mat works but needs an independent pump to work better

[@cordawg17]

can you link the check valve you used?

[@johnowenbuhay8969]

Hi. Do you have the link for the black rubber adapter you used?

[@marcogomez851]

Whats the white Intex inútil that u have next to the heather?

[@davidthompson7344]

Intex salt water chlorinator

[@dwayned5649]

what's the name of the hot/cold hose that runs from the filter to heater and then to pool please?

[@smashengineeringoffical]

I used the hose that came with the filter setup look at pool hose on Amazon it should come up

[@davidthompson7344]

I believe those are just 1.5" Intex brand flex hose

[@lorirotruck5450]

You jumped the entire beginning and assumed we know more than we do

[@smashengineeringoffical]

What do you need more info on?

[@davidthompson7344]

what is the fitting on your heater that reduces to the 1.5" flex hose? I can't find those anywhere😥

[@tracyfischer7978]

I was thinking of this heat pump too. Either that or the fh135. I only have 110v going out to my pool so I have to get a smaller heater. My pool is 24foot round though and I know it's technically too big for this pump, but my pool is freezing and gets no sun. How many gallons is your pool and do you recommend this heater? Thanks for the instructional video!

[@smashengineeringoffical]

I think it's 10000 gallon

[@jonketola7897]

Did you ground your fh120?

[@smashengineeringoffical]

yes i had to go grab grounding rod and some wire and clips. didnt film it because that part should be done by a professional .