PORTED NEOTEC NH872 BLACKOUT!!…..ITS GOT A PROBLEM🥴

[@wayneanderson991]

My experience with the 372 clones, automatically change coil to a Taiwan or German coil and replace the crank seals with Hyway or oem, before getting started with a new build. If issue with tuning arise change carb and intake boot and metal ring to oem. Every clone 372 I own, 4 currently has had all of these parts changed out to make them reliable long term.

[@cheba4786]

👍😁

[@alltherpm]

I put a 268 open port piston in mine, and did opened transfers hope its strong

[@vincentnail2881]

Curious to see what's going on with it. I will stay tuned.

[@Aaron_A_Lynch]

Well I changed the coil and think it’s fixed now

[@vincentnail2881]

@Aaron_A_Lynch Very cool man. Easy enough. Love the videos. Every saw seems to have a needed tweak here or there. Great work man.

[@dannywhelchel4801]

Im sure you will have it cutting super good in no time at all

[@brandonf1226]

Was the coil makin iratic idle as well?

[@Sawz_R_Hot_Hogz_R_Shot]

Why buy a Neotec over the Farmertech ? Fairly honest question? 🤔

[@Aaron_A_Lynch]

I bought a few a couple years ago to see what they was about just now getting into this one..not impressed🥴

[@larryw5429]

Why use the 266 piston over the 268? Honest question? But sounds like that saw rips pretty good! But I would agree with Coil my 865 coil started doing all kinds of weird things including run like a rev limiter limp mode kicked in and wouldn't rev up. Had factory blue coil and problems went away!

[@Aaron_A_Lynch]

I like the full skirt on the 266 piston..better support at high rpm

[@TightWadDoc]

The neotec, is it closed port like the FT? I thought the 65cc were all open port until i seen a FT. Assuming all the round intake cylinders are closed port

[@Aaron_A_Lynch]

Yeah the nh872 is closed port..the nh865 is open port

[@TightWadDoc]

@Aaron_A_Lynch Is FT the only one doing the 65cc closed port cylinder?