Those 500i saws are really nice especially when you port them
@Truckpuller83-372SaWgUy14 күн бұрын
Awesome job sir! That thing is a certified ripper! I have no need for one but dang Id like to try lol
@Doc-Cole_Trickle-of-Chainsaws14 күн бұрын
👍🆙🦎😁
@Doc-Cole_Trickle-of-Chainsaws13 күн бұрын
On the FT stuff(G660), Do you reuse the piston pin clips and both piston rings or just one? Not going 4 a racer, just going 2 be milling w/ a 36" bar. Cylinder is fairly clean cast, gonna cleanup and direct the ports, clean the piston up a little, widen the exhaust, muffler is done, gonna shoot 4 @ 5° ignition advance no more than that. Efficient flow in - out w/ ignition advance and gasket delete is the plan 4 now.
@Aaron_A_Lynch13 күн бұрын
@Doc-Cole_Trickle-of-Chainsaws use it all
@Doc-Cole_Trickle-of-Chainsaws13 күн бұрын
@@Aaron_A_Lynch 👊
@Aaron_A_Lynch13 күн бұрын
👊🏻
@tazman-kennyfuller14 күн бұрын
Nice work Aaron. Saw is flat rippin. Lovin it. 🌲❤️🌲👊🪓
@Sawz_R_Hot_Hogz_R_Shot14 күн бұрын
🪓
@Sawz_R_Hot_Hogz_R_Shot14 күн бұрын
Where’s Kwizzy and that 455 rancher when you need him 🤷🏽♂️
@Dan_Akins13 күн бұрын
Nice one! Did u get the log on the ground?
@andyprice469614 күн бұрын
Sounds like she’s got the speed. Thing is ripping. How’s the pull? Doesn’t sound like it’s slowing much in a cut so I’d say good. Was that oak y’all cutting?
@Aaron_A_Lynch14 күн бұрын
Pulls like a train in any wood…that’s just old pine I’m cutting