Potensic Atom Drone Front Left Arm replacement

[@TEKVidsonline]

If you get a little flat head screw driver under the antenna wire and give it a little push, should pop right out of the connector. Worked for me. Not sure if its a quality control issue with yours or if the pliers glamped the connector onto the pin. But hopefully that tip helps someone. Ultimately its a pretty easy little repair. Thanks for the video

[@ReelFishersOfMen]

Thank you for the tip. I actually did that. My board may have had a previous defect as you mentioned. I have since decided, if I had to do it again, I would just strip the wire and solder to the wire. The repair i did still is working so... 🤞😅

[@bapzzy9495]

Thanks for the video! I needed it

[@ReelFishersOfMen]

Your welcome. Glad it was helpful! 🙏

[@queirozdrone]

Like 23 🎉 awesome video congratulations 🎉 watching you from Rio de Janeiro Brazil 🇧🇷

[@ReelFishersOfMen]

Thank you very much. God Bless you and Brazil 🙌

[@queirozdrone]

@@ReelFishersOfMen my pleasure my friend 🤝🇧🇷 I'm sharing your videos here 👏 congratulations

[@ReelFishersOfMen]

🙏

[@anoxer_97]

Hello, is it easy or difficult to disassemble and reassemble the camera?

[@ReelFishersOfMen]

I am sorry. I don't have any experience with that. Thanks for watching. God Bless 🙌

[@Tanrosher]

Thank you for the video. Is your ATOM drone still holding up in high wind speeds?

[@ReelFishersOfMen]

Very welcome. under 15mph winds it does great. thank you for watching. 🙏

[@Tanrosher]

@ReelFishersOfMen I've flown with original parts in 25-35MPH wing gusts without issue. I figured replacement parts would probably change its wind tolerance.

[@ReelFishersOfMen]

I did not notice any difference after replacing the one arm. I think if there was a difference the fact I only replaced One arm/motor would make the drone fly erratic, regardless of wind. Kind of like when you have a bad prop or debris in the motor axel. Interesting to hear what others have to say?

[@quattro4302]

Hola, how do you solve humidity in the camera?

[@ReelFishersOfMen]

Hola. Unfortunately, I do not know. Good luck though 🙌

[@elivanhaach8791]

How did u fix the antenna? Did you use glue? I guess you had some problems with the port for the antenna, right? I seperated the "docking port" and now I'm a bit confused how to connect the new antenna top the port. Greetings from Germany ^^

[@elivanhaach8791]

*You said you used superglue to fix it. Is the connection between the RC and the drone still possible?

[@ReelFishersOfMen]

Yes I used super glue. If you have that UV glue use that. Afterwards, drone worked perfectly. Hope you experience the same outcome 🫰 Good luck 👍

[@ReelFishersOfMen]

See below... and thank you for watching Germany! 🙏💛

[@elivanhaach8791]

​@@ReelFishersOfMenThank you!

[@fnunes84]

Thanks for the video! Its one atom 4k or SE ? Greats from 🇵🇹

[@ReelFishersOfMen]

Your welcome. It is Atom 4k. Thank you for watching. God Bless 🙌

[@DaleK-j9g]

dont switch the placement of the blue wire...thats the signal wire

[@ReelFishersOfMen]

The new arm comes with a White, Red, Black orientation. No Blue. Therefore white replaces blue. Tested and confirmed. Thank you for your comment and allowing me to clear up any confusion for other viewers. 🙏 God Bless 🙌