How to remove centre console from Range Rover Evoque 2012

[@sliderdriver1]

Very clearly explained friend. Very handy to get access to the gear selector when that goes wrong…..and they do. Many thanks.

[@Trogvars]

Thanks a lot! For this video and for this channel! Official service asked 250 euros for this work.

[@ricks247]

Absolutely brilliant. We were quoted £150 to have the chrome side panels in our evoque wrapped in a carbon film. Thanks to this video, I took the parts out myself and wrapped the panels in my kitchen. Total cost of £5.08p and a few minutes watching this vid. Thankyou for posting. Don't suppose you have a vid showing how to remove the stop start button panel too do you?

[@L663]

It may be after this process you get a handbrake error but after you turn the ignition on a couple of times the fault should clear.

[@ceciltan2882]

very clear and useful instruction as I am planning to change my dented alu trims. On a side note... have done a video on how to remove the headrests of the front seats?

[@Jaysin13]

Thank you so much! Really well done, and explained.... I need to replace by stupid gear selector...

[@dih0p]

Hi there. Do you have video with rear vent removing that is connected to centre console. Thank you

[@L663]

Hi - my car is the 5 door model and they only fitted these to the 3 door models...I think they just pop out but will take a look. Out of interest why do you want to change them ? colour change ?

[@JayKay-ht8rg]

Just what I needed. Thankyou!

[@Roberto9139]

Esse conteúdo é show! Abraços do Brasil 🇧🇷

[@L663]

Hi - yes i plan to do this next week so i can get this done on my car also !

[@casperclarkemusic]

Hi, Is the process the same for a manual Evoque? If you can please let me know as I am looking to purchase replacement side trims

[@JustMarkavalli]

Thank you for this, please how do you get to the airbag module to send it off to be reset please?

[@simonjefferson]

There is no need to do this - can you reset this with an IID tool from GAP Diagnostics.

[@peterromaniuk5771]

Hi, Always enjoy watching your strip downs & was wondering whether you could possibly go a bit further & show us how to remove the EVOQUE touchscreen? I have an issue with mine & need to check whether the plugs are secure. Seen a couple on YT, But a more step by step approach from you guys would be great.....

[@denishalls2816]

Can you advise if the handbrake release loop is in there same as your video on the Sport?

[@CACTUS48]

Hi Thanks, I just bought a 2017 RRV 34K miles, the console side stainless steel trim has some dents in them, may replace them. Pennsylvania USA

[@gold-6680]

Hello! I did exactly what you did, but I lost the screws that came in the tunnel of the centre console, precisely those at 0:20. Do you know what are the dimensions of that screw or how i could find it?

[@L663]

I tried to find them on the parts catalogue but they are hard to find - sorry

[@gold-6680]

@@L663 thanks tho

[@djscottyboy]

hi there Do you have any videos on how to change the bonnet vents on Range Rover Evoque cheers scott

[@sebastianquinn1530]

Thanks for the video. Because I didn’t disconnect the battery I’ve now got a handbrake fault wire. How do I turn this off?

[@L663]

It will disappear after 3 ignition cycles

[@sebastianquinn1530]

@@L663 fab thanks. I managed to find a video that explained how to take it off anyway…putting the car into brake maintenance mode and then out of it again…went straight off :) Thanks for taking the time to reply

[@Stephenlightley]

Hello do you sell the centre console aluminium trim? Or know a good place to get one thanks

[@lngrn36]

Thanks for making all these videos! Can we remove the matching bit of trim from the dash to have a carbon fiber look all around?

[@alexzandercolten9628]

instablaster.

[@Gahbouch193]

How of you do this on the L405? will you be making videos for that model?

[@L663]

boss wont let me have a L405 to play on yet... still too expensive !

[@knight3131]

Where can you purchase the center console in black?

[@hokiepokie333_CicadaMykHyn]

Pornhub, of course... Lol

[@Jojoina]

Do you know how to remove the air vent covers?

[@L663]

the ones on the dash ?

[@prakashchandra3353]

Hi HOW DO I OPEN THE LOWER STEERING DASH BOARD PANEL AS I DROPPED MY SMART KEY IN THE SLOT AND NEED TO RETRIEVE IT BACK

[@L663]

not good ! is your car RHD like UK models ?

[@chrisjako3404]

Hi, Great video thanks! Would you recommend disconnecting the battery before remove this console? reason I ask is because the traction control ECU will detect handbrake not active and give you a warning light for traction control which will need to be disabled by the dealer - or will this not happen? Please can you be so kind as to let me know

[@L663]

+chris jakubowski You are correct - i have now added this as a note at the start of the video !

[@chrisjako3404]

Lol thanks, i actually forgot to do this last night when replacing a fuse and got fell for the error message, got a call from the wife this morning about the warning light - will tell her to cycle the ignition thrice - thanks again

[@sebastianquinn1530]

@@chrisjako3404 I’ve just done this and didn’t disconnect the battery. How do I turn off the warning light?

[@andymazilescu6479]

Thank you

[@L663]

Welcome!

[@r3issi]

Why? Because they are easy to pull apart?

[@weneedtodosomething]

im sorry but every time he takes a range rover apart.... the build quality just seems lacking

[@tjbeautys2138]

my radio just stop work? today what is going on it`s a 2012

[@jnew6808]

You are the Fucking Best! Thank you

[@crossmeistergeneral]

Has anyone tried this with a manual gearbox?

[@franckbertoltakoukouo2792]

C'est géniale

[@L663]

Merci !