Powerstroke 6.0L Turbo Noise and Failure

2006 F250 Powerstroke 6.0L with failed turbo.

[@ojmcbaggins]

I thought my turbo bearings were going in mine! This confirms it

[@HarrygTV]

Thanks for watching and commenting.

[@ProleDaddy]

There are only bushings in this turbo and nearly all turbos out there.

[@lianleonard6357]

I have the same problem right now bro. Thanks for this video i thought it was the mas sensor

[@Mels-Garage]

I might have a clogged converter and bad turbo bearing, have the same bearing noise with your test plus excessive swoshing sound at idle. Thanks for the video, disconnecting it tomorrow

[@HarrygTV]

You're welcome! Thanks for watching and commenting.

[@psd28]

Delete the cat

[@ProleDaddy]

This truck has neither bearings in the turbo or a cat.

[@MERICANMOTO]

Mine when you floor it it builds boost up to a certain point then has a loud whistle and the truck start choking only happens slightly after it starts doing the 6.0 growl idk how to explain it very good but any idea?

[@ricodegallo3060]

👍

[@mikegomez5796]

In my car it sound like the turbo comes in and out. Almost like a misfire

[@danielmart9997]

I just replace mine had the same problem

[@gabrielcortes6087]

I have the same problem what would you recommend me to do

[@gabrielcortes6087]

Should I just buy a new turbo wheel ? Or replace the turbo

[@HarrygTV]

Replace the turbo.

[@manassehgiesbrecht6528]

If you have a turbo like this is it possible to rebuild it yourself

[@ProleDaddy]

Yes. Plenty of YT videos out there on this.

[@oldmanintheshopbuiltnotbou8726]

turbo was noisy

[@HarrygTV]

Seems like it could only build a third of the boost it needed.

[@maximusilive4theking986]

I'm getting humming sound right around 50miles per hour, truck has been fully bulletproofed about 2 months ago and just recently started getting that hum. Truck runs great, shifts great, idles great but just around that speed I get that hum, goes away right around 45 and above 55 to 60mph, any ideas?

[@HarrygTV]

Maybe the rear end?

[@maximusilive4theking986]

@@HarrygTV no, it's coming front the front end driver side, I narrowed it down the wheel bearing. When I make a right or on rd going right the noise seems to disappear

[@miguelventura7651]

What kinda boost on excell?

[@HarrygTV]

Sorry, I don't remember exactly what it was. It did make some small amount though...

[@doughoy3239]

Will a bad turbo cause tranny issues? Mine is in the shop currently. Has a bad grinding noise in the floor board and the shop is telling me the trans is fine

[@HarrygTV]

Turbo problems cause low power, which makes the trans shift odd...

[@seanjsimon]

FICM can cause hard shifts

[@masonwall612]

Hey Mine has same grinding noise, I can feel it in the floor, wasn’t sure if it was trans or not. Did you ever figure out what it was? Thanks.

[@tortew740]

Can the truck completely lose power because of a bad turbo?

[@HarrygTV]

Yes. These trucks have very little power without boost.

[@tortew740]

Mine shut off completely I got new boot and new turbo runs great now@@HarrygTV

[@tortew740]

My cold side boot to the had cracks in it@@HarrygTV