Predator 212 Chamber shape, porting, Trinity set … Paulskarts.com

[@BrendaGibson-ys6qn]

The amount of knowledge that goes into this is amazing! You are the man

[@paulskartslifan4206]

I appreciate that!

[@Black66]

That head looks beautiful! There has to be hours and hours into something like that.

[@paulskartslifan4206]

@@Black66 well it was for an 80mm bore so we needed to stretch out the chamber just a little hahah, but it is a lot of work. Thanks for noticing

[@turkeyboyjh1]

What’s your opinion on the wind up spring loaded starters, I like deleting or welding the compression releases in place, in makes for a steadier idle and I’ve had them come apart in the block before, this is fine on stock compression but on high compression it’s a problem, if the spring loaded starter can turn an 11 to 1 motor I can eat my cake and have it too

[@paulskartslifan4206]

Honestly I have never messed with spring loaded starters but my opinion is water you like for your build and think is cool go with it. These things should be a reflection of your personality. Have a great day. Paul

[@joelnevarez3058]

Quick question paul i have a tillotson 225rs and i just bought a 308cam what head do you recommend stock bore 72mm stock crank 55mm got a 28mm carb

[@paulskartslifan4206]

www.paulskarts.com/product/predator-212-tillotson-212-225-cylinder-head-welded-intake-tube-32-28-ported-guides-5-angle-welded-intake-tube/311?cp=true&sa=false&sbp=false&q=false&category_id=2

[@Wjjw8-k3i]

What will i need to put 32/28 and dual 40lbs valve springs on a predator because the ones people are selling are expensive and i want to use the stock cc head

[@paulskartslifan4206]

Well you’ll need seats installed and the seats cut , also a good time to do bronze guides. Then you’ll need spring pockets cut.

[@Timy-r1i]

I want to put a 330 lift and 280 duration cam on a predator 212 but I don't know if the duration is to much for it to run right

[@paulskartslifan4206]

Its got to much duration. You need more compression ratio to run that cam. Hard to even get the 12:1 that a 260° cam requires.

[@mikequesenberry7976]

I got a 356 cam 1.3 rockers and a shredder head that flows 120 but wet flowd alcohol 30mm carb 15.5 to one you think it will run close to 30 hp

[@mikequesenberry7976]

Its 462 lift and i plan on turning 10k rpm 32 25 valve 212