Pro Pressing 1inch fittings with the Vevor pro press and checking for leaks 💧.

[@anthonyalegria4695]

I bought one because of your videos and it works perfectly

[@levi5016]

@@anthonyalegria4695 nice, glad to hear that.

[@jinsong6940]

I bought one myself today and your videos helped. Thanks. Dont listen to the naysayers on here, propress might be new in America but its well tested in Europe.

[@levi5016]

@@jinsong6940 nice!

[@matt_balomenos]

Keep the videos coming. I have one, but haven't used it yet. I'll be doing water heaters and other stuff by myself soon, so then I can try mine out for myself.

[@AlChilazoLife]

More videos with vevor please

[@perryflores2584]

Your the best😂

[@levi5016]

@@perryflores2584 thank you Perry Flores 🫡

[@Davewolfy]

What fitting manufacturers cover a failed crimp with a vevor pro press. ?

[@old1234]

Have you used the included 1/2" jaws? I just got one of these and did a few 1/2" fittings. Mine doesn't leave the hex indentations on the end of fitting (the side the pipe is inserted into). It does press the o-ring groove and the leaves the hex indentations on the top side of the fitting. It looks like the hex portion of the jaws are too wide to engage both the top and bottom halves of the fitting. I dont have one to compare but I'm thinking Ridgid and Milwaukee 1/2" jaws are narrower? Any insight?

[@levi5016]

@@old1234 yes I have used the 1/2inch fittings and I have not had any issues also I’m sorry but I dont have any insight on that but I do know that you can use both the Milwaukee and Ridged jaws on the Vevor pro press.

[@old1234]

If you get a chance grab a 1/2" fitting and set it in the vevor jaws (don't have to crimp) and see if the hex part contacts on both sides of the o-ring. On mine only one side contacts like the jaws are too wide. Next compare it to your Ridgid compact jaw, see if the hex will contact on both sides. I don't have any other jaws to compare but I think the hex should contact on both sides. This could be a big problem with the vevor jaws

[@1dgrdgr]

@@old1234 is that your review on their website? If not, there is someone else that mentioned the 1/2" jaws don't contact the pipe side of the fitting.

[@old1234]

No it is not my review. I basically stopped using it for 1/2" fittings because I don't trust it. Now my press completely stopped working. It won't turn on any more. I only had ~50 or so crimps. Hopefully they will warranty it. I wouldn't buy one of these again.

[@666-y8w]

Well, that was a worthless video.