Prolux Trim Iron - Review - RC Balsa Aeroplanes - Heat Shrink Film Covering Iron

[@hartdgs8268]

Thanks for the review Mark. I have been thinking of buying one of these, your review has convinced to get one.

[@MarkRobinson555]

Excellent, pleased it was useful, thanks for the comment 😀

[@Tom-wl9sx]

Hi Mark, bought one myself recently. I'm very pleased with it, well worth buying 😉

[@MarkRobinson555]

Great to hear!

[@Elnufo]

Great review, well done! 😊

[@MarkRobinson555]

Thank you! 😀

[@terryblackman6217]

Great review there Mark. I also have been meaning to get one of these irons.

[@MarkRobinson555]

Hi Terry, thanks for the comment, well worth the investment, I had been thinking about getting one for ages, so glad i did 😀

[@robertwoolley8632]

That was an interesting review Mark. I have had one of those trim irons for some time and was hoping it would perform as per your demonstration but I find mine struggles to get the shoe sufficiently hot to fully stick down the covering. Perhaps I need to give it another attempt.

[@MarkRobinson555]

Thanks 👍

[@thercbarn5001]

I have the trim iron by monokote. It only has a high low switch and low didn't seem hot enough and high is too hot. I like the idea of this one with the knob. I'll have to get one. Thanks for the review. Mike

[@MarkRobinson555]

Your welcome, pleased you found it useful

[@homienat3374]

Nice 1 mark was doing them niggling bits today with the large iron ,pain in the but ,must invest in 1 of these

[@MarkRobinson555]

They are a great bit of kit, well worth the investment

[@todd718]

Is there a place to buy the model 1350 in the US?