PROTECT your JB4 with these aluminum covers

[@sttng3.3r_68]

Thank you so much for the install footage. I got these last week off a local shop and wrapped them in carbon fiber vinyl, but wasn't able to install them til now. Props man! I was just following before, but now I'm here to stay lol 🤙

[@twn2rbo]

Sick! I’d like to see those, love carbon fiber. He also has the carbon fiber strut bars that I want, would match that perfectly. Check them out on his website I linked in the description

[@cmack5384]

Another good video man. Thanks for looking out for us with the discount! Sooo close to that 3k!!!!

[@cadillacats-qb8nr]

Just ordered for my G70 and used your promo code for the discount. Thanks!

[@twn2rbo]

Absolutely! Thanks for watching the vid 👊

[@mitsevox]

just bought these and used your code, thanks man!

[@twn2rbo]

Appreciate it man

[@rousseau7719]

Just had my 2020 awd Stinger dynoed. Only mod was BMS intakes. It made 340hp 400 torque. It was on a dynojet, so it may have read alittle higher in numbers

[@twn2rbo]

Nice, I’ve located a AWD dyno, 30 min drive, I will make that video before the next performance mod goes on to see where we are

[@RealExpertsPro]

Nice watch. I love how you even wear it to work on the car. #baller

[@twn2rbo]

👊💯I’ve been obsessed with watches since I was 13. I always wear one but sometimes I take it off if the install is harder

[@that_red_stinger8649]

I'll be ordering some for the ultimate clean finish.

[@Civilian_Patriot]

I’m getting these for sure

[@purrly8578]

Has anyone ever mounted their JB4 on the opposite side by the ECU? I saw it in a pic one time and liked the idea to have it under the stock cover. But now these vanity covers solve that problem regardless.

[@SlipAngleG70]

You can run the JB4 cables through the hole below the vanity covers go.. much cleaner that way. Just pull the plug out.

[@twn2rbo]

Oh absolutely, this is getting re ran, I’ll prob make a vid showing the fuse tap and then do that all at the same time to see how clean I make it look.

[@SlipAngleG70]

I re-read my comment and wondered if it's clear enough... At the 1:37 mark of your video, you can see the hole. 1 o'clock position above your catch can.

[@twn2rbo]

@@SlipAngleG70 perfect! I’ll give that shot , I would have in this vid but I didn’t bring any wire snips since I went or the park 😆. I put a zip tie on the some of the excess wires last time, one of which runs to the passenger side red 02 wire. Also, I’ve seen you name pop up a lot since I started the channel and just want to say thanks for hanging this whole time and leaving good comments 👊👊 appreciate it

[@nickypellot]

I just bought a 2020 stinger GTline, is it worth it to put in a JB4 on this model?

[@twn2rbo]

I’ve seen some pretty impressive results. Whenever a turbo is involved, esp now days, I would say 100% yes. There’s no replacement for displacement when comparing to say the Stinger GT, but you will beat a lot of cars, esp if AWD and they make a TCU tune for it.

[@nickypellot]

@@twn2rbo I appreciate you, keep up the great content 💯

[@1state152]

Almost 3k time to start sending me over the much need spark plug giveaways haha 🔥🔥🔥🔥🔥🔥😍😍🥃 jk but I’m itchin lol

[@twn2rbo]

Well if ya miss the spinning wheel this time, there will be 4K and 5K chances again. 10k JB4. I want to figure out a way to get more companies to sponsor a crap ton of giveaways for you guys. 👊

[@1state152]

@@twn2rbo that would be awesome! Keep doing what your doing man wish u all the best with your channel and helping out the community 🔥🥃

[@twn2rbo]

@@1state152 will do, appreciate the support bro

[@PatC1]

#KDM_Curt got them here: kzbin.info/www/bejne/h4mzmKqffratfbM

[@8uck2hot]

I know you’ve probably had a video on this but I’m a busy man as well but what BOV’s are you running dude? I’m running GFB and they sound like star wars blasters when blowing off. 😩

[@twn2rbo]

I’m stock there bro! The intakes really made a lot of noise over here 😂