Prusa mk3s - 3kg fail

[@ruben-b4]

oof

[@GolemShadowsun]

main problem: you use a stand on spool roller without any enclosure. was always an unnecessary risk. and i never get why ppl use them at all. if there is any knot or other problem, they will get pulled down and cause problems. even worse problems than the extruder motor grinds down the fila and the print fails from feeding problems.

[@mrsarge]

This was my first time using a 3kg spool. Never had stuck filament like that on a 1kg spool before so didn't think this would happen. If I ever buy one again, I'll add something through the center of the spool to retain it if it jams like that.

[@xathridtech727]

Basically the reason i only bought a single 3kg roll and then rewound 1kg spools

[@mrsarge]

Just did that for the remaining filament and had a hard time doing it. Every time you reach the cardboard side, the filament is to tight and is stuck.

[@magus104]

That stinks. Though video tutor implies this is somehow the printers fault? I guess maybe it could have detected something funky with the tension and paused instead

[@mrsarge]

MK3S+ has a Crash Detection (with a lot of false positive) but i'm running Klipper at the moment so I don't have it anymore.

[@RebelPhoton]

No no no no no NO! No no no noooooo!

[@capucine58]

Je suis crampée 😂