Рет қаралды 4,462
I spent time with renowned tool maker Nic Westermann of ‘Hewn & Hone’ at his workshop in rural Wales
=============================================================================
Click the links below to access the tools and materials referenced in this video:
Fully Completed Sloyd Carving Knife - www.hewnandhone.co.uk/product...
Turning Sloyd Blank - www.hewnandhone.co.uk/product...
Turning Sloyd Blade - www.hewnandhone.co.uk/product...
=============================================================================
Connect with Hewn & Hone using the links below:
Hewn & Hone Website - www.hewnandhone.co.uk
Hewn & Hone Instagram - / hewnandhone
=============================================================================
The other videos I filmed with Nic Westermann:
Nic Westermann - Important updates, Ordering tools, Waiting list, Etc - • Nic Westermann - Impor...
Hewn & Hone - Introduction by Nic Westermann - • Hewn & Hone - Introduc...
[Step by Step] Build A Two & Half Brick Forge - Nic Westermann - • [Step by Step] Build A...
(Pt 1/5) How To Make A Turning Sloyd Knife - Forging, Annealing & Rough Shaping - • {Pt 1/5} How To Make A...
(Pt 2/5) How To Make A Turning Sloyd Knife - Heat Treat - • {Pt 2/5} How To Make A...
(Pt 3/5) How To Make A Turning Sloyd Knife - Establishing Profile & Grinding Bevel - • {Pt 3/5} How To Make A...
(Pt 4/5) How To Make A Turning Sloyd Knife - Handle Making & Fitting - *THIS VIDEO YOU ARE WATCHING*
(Pt 5/5) How To Make A Turning Sloyd Knife - Sharpening & Maintenance - • {Pt 5/5} How To Make A...
=============================================================================
Below is a timestamp of all the sections in this video:
(Click on the time on the left to go straight to that section)
00:00:00 - Start
00:00:02 - Introduction
00:02:20 - Recap
00:03:04 - Beginning the process
00:04:18 - Wood selection
00:05:04 - Green or dry wood
00:05:55 - Lee stoffer shavehorse
00:06:21 - Carve main four sides
00:09:44 - Carve 1st set of facets
00:10:58 - Carve 2nd set of facets
00:13:39 - Handle sizes
00:16:23 - Carving end facets
00:17:43 - Marking hole
00:18:57 - Drilling hole
00:23:52 - Pulling blade out of handle
00:24:44 - Oiling handle
00:27:05 - Epoxy glue
00:29:34 - Insert blade into handle
00:30:52 - Epoxy glue
00:31:41 - Wiping off residue
00:35:11 - Drying & setting
00:36:57 - Conclusion
00:39:27 - Outro
=================================
As always I appreciate you watching
Take care
Peace
Zed
#handle #toolmaking #knifemaking