PTC Creo 8: Drawings - Placing center-lines on a circular hole pattern

[@admanajw]

I was searching for a non existent centerline button for the past hour. Thank you!

[@timbarrett4580]

Great video! Thanks for the tip! Is it possible to do this with rectangular patterns as well? It's kind of annoying to have to resize the datum axes whenever a dimension or scale changes.

[@kalle6850]

thanks just oiled up and it worked great tutorial 👍

[@danielgamarra3479]

Is it possible to trim that circle? for example I wanna show only the semi-circle in the drawing.

[@Stocjon1985]

I did exaclty the same procedure and did not work.

[@jbijnens]

How did you create the holes? Did you create them like in the video?

[@Stocjon1985]

@@jbijnens take a look. kzbin.info/www/bejne/Z4GtZpmQr9l3rKM

[@jbijnens]

@@Stocjon1985 I've recreated your part in PTC Creo 8.0.4.0 and I couldn't recreate your problem. The end result on my end is every time the same as what can be seen in my video. What you could try is the following Change the drawing option radial_pattern_axis_circle to "yes" in the drawing properties before trying to create the center lines.

[@Stocjon1985]

@@jbijnens After changing the option as you mentioned it worked. Thank you very much for your support.

[@megamelonman7762]

Didn’t work

[@jbijnens]

Hi, I have two questions. 1. What Creo version do you use? 2. How did you create the holes?

[@jacobbelmontes4899]

Good video, music was lame though