Pulling liners on the Massey Harris 44 Special engine

[@daleswalley7226]

It’s getting there.😉

[@clarencetrice4442]

😊😊 U have 2 see 👀 😊 if there's a good set of cylinder sleeves or have a set made that engine has a 4 inch bore and a 5 1/2 storke / most likely they are broke from old age 😮😮 U put the cylinder sleeves in W a hammer 🔨 and a block of wood 🪵 😊 they do go in better when U put them in a deep freezer and they should have frost on the cylinder sleeves 😊😊 OMG 11 27 2O24

[@stevehill4615]

I go even further on Perkins'3.152 motors with dry liners in that not on do I put the liners in the freezer for at least 12 hour but I'll point a space heater at the block for for an hour or so to get the block as warm as possible (bit more than hand touch hot) so the combination of the expansion of the block and contraction of the liners helps as much as possible (on that Perkins 3.152 with dry liners i was able to virtually drop them in, only needing to use the wood block and hammer for final seating of the liner).